Hearth and Home Technologies 6000BE Wiring the Fireplace, Optional Accessories, Wall Switch

3/16” PIGGYBACK CONNECTOR			BLACK S2	REMOTE SWITCH
				PIGTAIL
			ON
			OFF
	WHITE T2		ON/OFF
			SWITCH
GAS VALUE	RED T1
		THERMOPILE
THERMOCOUPLE				OPTIONAL WALL SWITCH,
		BLACK S1
Figure 35. Standing Pilot Ignition Wiring Diagram				THERMOSTAT OR REMOTE

Step 9. Wiring the Fireplace

NOTE: Electrical wiring must be installed by a licensed electrician.

CAUTION: DISCONNECT REMOTE CONTROLS IF AB- SENT FOR EXTENDED TIME PERIODS. THIS WILL PRE- VENT ACCIDENTAL FIREPLACE OPERATION.

For Standing Pilot Ignition Wiring

Appliance Requirements

•This appliance DOES NOT require 110-120 VAC to operate.

!WARNING: DO NOT CONNECT 110-120 VAC TO THE GAS CONTROL VALVE OR THE AP- PLIANCE WILL MALFUNCTION AND THE VALVE WILL BE DESTROYED.

Optional Accessories

Optional fan and remote control kits require that 110-120 VAC be wired to the factory installed junction box before the fireplace is permanently installed.

Wall Switch

Position the wall switch in the desired position on a wall. Run a maximum of 25 feet (7.8 m) or less length of 18 A.W.G. minimum wire and connect it to the fireplace ON/ OFF switch pigtails.

WARNING: DO NOT CONNECT 110-120 VAC ! TO THE WALL SWITCH OR THE CONTROL

VALVE WILL BE DESTROYED.

CAUTION: LABEL ALL WIRES PRIOR TO DISCONNEC- TION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPERAND DANGEROUS OPERATION. VERIFY PROPER OPERATION AFTER SERVICING.

		VARIABLE SPEED CONTROL
			NOTE: IF ANY OF THE ORIGINAL WIRE
			AS SUPPLIED WITH THE APPLIANCE
	BLK	BLK	MUST BE REPLACED, IT MUST BE
		JUNCTION BOX	REPLACED WITH TYPE 105OC RATED WIRE.
BLK		BLK	BLOWER RECEPTACLE
			BLK
	BLK
			BLK

WHT WHT

BLK

GROUND

TEMPERATURE

SENSOR SWITCH

BLOWER

GRN

BLKWHT

110-120 VAC

BLOWER	SENSOR
	SWITCH

“FAN”

RECEPTACLE SPEED CONTROL

Figure 36. Fan Wiring Diagram

Hearth & Home Technologies • 6000BE, 6000BE-IPI • 2024-900 Rev. G • 11/05 29