Frigidaire 318201616 Cable from Residence, Black, Wires, Box, Or Bare Copper, Listed

Page 7

30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

Direct Electrical Connection to the Circuit Breaker, Fuse Box or Junction Box

If the appliance is connected directly to the circuit breaker, fuse box or junction box, use flexible, armored or nonmetallic sheathed copper cable (with grounding wire). Supply a U.L. listed strain-relief at each end of the cable. At the appliance end, the cable goes through the Direct Connection Hole (see Figure 5) on the Cord Mounting Plate. Wire sizes (copper wire only) and connections must conform to the rating of the appliance.

Where local codes permit connecting the appliance- grounding conductor to the neutral (white) wire (see Figure 5):

1.Be sure that no power is supplied on the cable from residence.

2.Remove the grounding strap from the terminal block and from the appliance frame.

3.In the circuit breaker, fuse box or junction box:

a)Connect the green (or bare copper) wire, the white appliance cable wire, and the neutral (white) wire together.

b)Connect the 2 black wires together.

c)Connect the 2 red wires together.

Cable from Residence

Neutral		Black
(white) Wire		Wires
Red
Wires
		Junction
		Box
		White Wire
Green		U.L.-listed Conduit
(or Bare Copper)		Connector (or CSA
Wire	Cable from	listed)
	Appliance

NOTE: Be sure to remove the supplied grounding strap.

Figure 5

3-Wire (Grounded Neutral) Electrical System

(Example: Junction Box)

Where local codes DO NOT permit connecting the appliance-grounding conductor to the neutral (white) wire, or if connecting to 4-wire electrical system (see Figure 6):

1.Be sure that no power is supplied on the cable from residence.

2.Remove the grounding strap from the terminal block and from the appliance frame.

3.In the circuit breaker, fuse box or junction box:

a)Connect the white appliance cable wire to the neutral (white) wire.

b)Connect the 2 black wires together.

c)Connect the 2 red wires together.

d)Connect the green (or bare copper) grounding wire to the grounding wire of the circuit breaker, fuse box or junction box.

Cable from Residence

Green (or Bare

Copper) Wire

White Wire

Red

Wires

Black

Wires

Green (or Bare

Copper) Wire

White Wire

	Junction	U.L.-listed Conduit
	Box	U.L.-listed Conduit
	Box	Connector (or CSA
	Cable from	Connector (or CSA
	Cable from	listed)
	Appliance

NOTE: Be sure to remove the supplied grounding strap.

Figure 6 – 4-Wire Electrical System

(Example: Junction Box)

7

Image 7

Contents

Leveled hatched area These surfaces should be flatImportant Cabinet and countertop By the leveling legs and not by the cooktop itselfWidth should match the cutout width Raised ShaveEdge To Clear Space for a 31½ 81 cm Wide Cooktop Serial Plate Location Important Notes to the InstallerInstall anti- tip device packed with range Important Note to the ConsumerElectrical Shock Hazard Factory Connected Power Supply Cord Canada onlyPower Supply Cord Kit U.S.A Access to Terminal Block & Grounding Strap U.S.AFour Conductor Wire Connection to Range Three Conductor Wire Connection to RangeBox WiresCable from Residence BlackCabinet Construction Range InstallationCountertop Preparation Check Operation When All Hookups are CompleteBefore You Call for Service Leveling the RangeAnti-Tip Brackets Installation Instructions Important Safety WarningTools Required Canadá Approx 7/8Panel lateral 55.25 cmPuerta abierta Vea la notaDemetal Reborde delvidrio Lime el ½ Max BordeNúmero Nota importante para el consumidor Notas importantes para el instaladorEncontrará el modelo y el Peligro de choque eléctrico Estuche de cable del suministro eléctrico U.S.AEléctricos Conexión del cable a tres alambres la cocina Conexión eléctrica a la cocina Estados UnidosConexión del cable de cuatro conductores a la cocina Conecte los dos alambres negros juntos Desconecte el suministro eléctricoAlambres vea figura Alambre neutral blanco juntosInstalación sin paneles laterales Preparación del mostradorInstalación con un protector trasero Antes de Llamar al Servicio Comprobación del FuncionamientoDespués de Terminar la Instalación Ubicación del Número de Modelo y de SerieInstrucciones de Instalación del Soporte Antivuelco SeguridadHerramientas Necesarias Pour Votre Sécurité N’entreposez pas ou n’utilisez pas Niveau région hachuréeTout autre appareil électroménager 22 7/8 58,1 cm min 23 1/4 59,05 cm max See note 86 cm Panneau latéralAu moins Arasez leDessus du Comptoir à’oubliez pas de laisser ces instructions au consommateur Emplacement de la plaque signalétiqueAccès au bloc de connexions et à la plaque de mise à terre Ensemble de cordon dalimentation États-UnisRisque de choc électrique Abaissez le couvercle des bornes du bloc de Cuisinière U.S.ARouge à la borne de droite, et le fil noir à la borne de GaucheDalimentation Débranchez lalimentationReliez ensemble, le fil blanc, le fil vert dénudé De lappareil et le fil neutre blanc du câblePréparation du dessus de comptoir Installation de la cuisinièreVérification du Fonctionnement Emplacement des numéros de modèle et de sérieAvant d’appeler le service d’entretien Mise à niveau de la cuisinièreTourne‑écrou de 5 /160,79 cm ou tournevis à tête carrée Instructions d’installation des supports anti‑basculeImportantes Outils RequisInstructions Dinstallation Pour LA Cuisinière 30 Encastrable Instructions Dinstallation Pour LA Cuisinière 30 Encastrable