Avoid Service Checklist (continued)
PROBLEM | POSSIBLE CAUSE/SOLUTION |
|
|
|
|
(SOME MODELS) |
|
|
|
Follow steps specified in this manual for appropriate settings of controls. | |
|
|
| Door was not closed properly. Close door and start appropriate clean cycle again. |
Soil not completely removed after self-cleaning cycle.
Failure to clean the bottom or front top of oven or door area, these surfaces get hot enough to burn on residue. Self cleaning of area underneath a closed door is not efficient. Clean these areas before the
Clean cycle too short. Put oven through an additional cycle.
Check for temporary loss of power. Reset the controls and put the oven through another
Avoid Transportation Damage to your Range
If you have to move your range into/out of your residence or when moving to a new home, it is suggested that you take the following precautions:
1.Screw in the levelling legs under the range.
2.Remove the racks and other utensils from the oven, and from the lower drawer.
3.Use adhesive tape to firmly secure the door and the drawer to the side panels. Also attach the electric power cord in the same manner.
4.Use a
5.Avoid pulling or pushing the control panel when moving the appliance.
27