Avoid Service Checklist (continued)
PROBLEM | POSSIBLE CAUSE/SOLUTION |
RANGE DOES NOT OPERATE
Surface elements do not heat.
No power to range. Check steps “Entire range does not operate” above.
Control knobs set too low. At very low heat settings of the control knobs, the surface signal light may come on; however, surface unit does not operate. Turn the control knob to a slightly higher setting until the elements start heating.
Coil elements not seated properly in terminals. Turn temperature control knobs to OFF. Pull out and lift up coil elements. Straighten terminals on end of coil element if necessary. Replace elements properly into the element block.
Incorrect surface control knob turned on. Make sure the correct surface control is on for the surface unit to be used.
The automatic lock off of the surface element is on (models with
Oven light does not work. |
Control panel light does not oper- ate (some models).
Lamp loose in sockets or
SURFACE UNITS
Surface elements too hot or too cold.
Raise or lower setting until proper amount of heat is obtained.
Use only flat bottom, evenly balanced, medium or
Liquids boil at LOW setting of sur- face units.
Incorrect setting of the control knob. Turn control knob to a lower setting.
Cooking on right rear element. When the oven is operating, heated air escapes through the oven vent located directly under the right rear end coil element or little behind it. This will increase the heat input.
CERAMIC GLASS COOKTOP (some models)
Scratches or abrasions on cooktop | See “Ceramic Glass Cooktop” section in “General Information” section. |
surface. |
|
NOTE: Clean sugary food spills on the heating surfaces as soon as possible, as these can cause cratering of these surfaces when hot.
25