Frigidaire 318200413 Oven Light, Surface Light, To level the range, To replace the light bulb

Page 6

Installation Instructions (continued)

UNLOCK

LOCK

LOCKING THE FRONT ROLLERS (some of the 30” models only)

Oven Light

To level the range:

1.Use a 1-1/4” open end key or an adjustable wrench to equally unscrew the four leveling legs two to three turns each.

2.Install an oven rack in the center of the oven.

3.Move the range to its final position, then put a spirit level on the rack to check for levelness. Take two readings, one with the level placed diagonally first in one direction, and then the other.

4.Use the 1-1/4” key or wrench to adjust the leveling legs. Turn each one until the range stands firm without wobbling.

5.Some models are supported by smooth glide rollers to facilitate moving.

If floor is flat and level, open the drawer and lower the front roller locking levers (some models) to prevent the range from moving.

If floor is not flat or level or if this model has rollers without locking levers, use the 4 leveling legs to level, support and prevent the range from moving.

Do not turn the oven light on during the self-cleaning cycle. High temperature will reduce lamp life.

On some models an interior oven light will turn on automatically when the oven door is opened. The oven light may be turned on when the door is closed by using the oven light switch located on or underneath the control panel.

On a self clean oven the lamp is covered with a glass shield held in place by a wire holder.

THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.

To replace the light bulb:

BE SURE OVEN IS COOL.

1.Turn the power off at the main source.

2.Wear a leather-faced glove for protection against possible broken glass.

3.Replace bulb with a 40 watt appliance bulb only.

4.For self-cleaning oven, press wire holder to one side to release glass shield, change bulb and be sure to replace glass shield.

Surface Light

(some models)

Be sure all surface element control knobs are turned off “” and elements are cool.

 

 

Use switch located on or underneath the control panel to turn the surface light ON/OFF.

 

 

Replace the surface light, if after repeated attempts to turn it on you are not successful.

 

 

30” RANGE SURFACE LIGHT REPLACEMENT (some models)

 

 

 

To remove and replace the fluorescent light:

 

 

 

1. Place your fingers under the tube at approximately 20.3 cm (8”) from each end.

 

 

2. To remove, turn the tube 90° then pull it down and out of its sockets.

 

 

 

3. To replace the tube, engage the new tube into the sockets, then rotate and snap the tube in

 

30” Models

place. Turn on the surface light to make sure it will lit.

 

24” RANGE SURFACE LIGHT REPLACEMENT (Some models)

 

To remove and replace the fluorescent light:

 

1.

Lift up the control panel cover.

 

2.

Place your fingers on the tube at approximately 20.3 cm (8”) from each end.

 

3.

To remove, turn the tube 90° then pull it out of its sockets.

 

4.

To replace the tube, engage the new tube into the sockets, then rotate and snap the tube in

 

 

place light to make it sure it will lit.

24” Models

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents
Range Record Your Model and Serial Numbers Product Registration Register Your Product Model Number Serial Number Date of PurchaseImportant Safety Instructions Listed in this owner’s guide. Before self-cleaning the oven Clean the range regularly to keep all parts free of greaseClean in the self-cleaning cycle only the parts of the oven Keep Oven Vent Ducts Unobstructed. The oven is ventedLocation Installation InstructionsClearances and Dimensions LevelingTo level the range Oven LightSurface Light To replace the light bulbSetting Type of Cooking Setting Surface ControlsModels with a self-cleaning oven only Circuit ProtectionSpecialty Pans & Trivets Canning Tips & Infor- mationPrevent damage to cooktop Indicator Light Baking Problems and Solutions ChartModels with Touch Pad Control only Oven Baking Convection Roasting some models Air Circulation in the OvenConvection Cooking some models Convection notesGeneral Cooking Instructions Speed BakeTM Cooking System some modelsBenefits of Speed BakeTM Cooking System To Set Speed BakeTM Cooking SystemOven Settings BroilingRegular radiant elements some models Ceramic Glass Cooktop some modelsTypes of heating units used Expandable radiant elements some modelsHot Surface Indicator Light some models Setting Warm Zone controls some modelsUse and Care of Glass Surface Problem Cause To Prevent To RemoveThings to Remember Aluminum foilDo not Use on Ceramic Glass Cooktop Cleaning Materials for Ceramic Glass CooktopDo Use on Ceramic Glass Cooktop To RemoveGlass Control Panel Cleaning the ApplianceSteel/Aluminum Control Panel Never immerse coil elements in waterFor heavy, burned-on soil Porcelain Enamel Cooktop Cleaning InstructionsDaily Cleaning For sugary spilloversCleaning the Regular Oven Non self-clean oven Preparing the Oven for Self-CleaningUpswept lift cooktop some models Setting the Controls for a Clean CycleTo Remove and Replace the Oven Door Lock in normal position Lock engaged for door removalRemovable Outer Door Glass Panel some models To Remove/Replace Storage DrawerSetting Warmer Drawer Controls Warmer Drawer some modelsTo Remove and Replace Warmer Drawer To Remove Warmer Drawer Warmer Drawer General CleaningArranging Warmer Drawer Rack Positions To Replace Warmer DrawerInstallation Avoid Service ChecklistBefore you call for service read this Range does not OperateSurface Units Ceramic Glass Cooktop some modelsPoor Baking Results BroilingSELF-CLEANING Oven Some Models Avoid Transportation Damage to your RangeRange Warranty Cuisinières Enregistrement du produit Enregistrez votre appareilNuméro de modèle Numéro de série Date d’achat Mesures DE Sécurité Importantes Conservez CES Instructions Emplacement Instructions d’installationEspaces prévus et dimensions BranchementLampe de surface Instructions d’installation suiteLampe du four Pour remplacer la lampe Pour mettre la cuisinière de niveauCoupe-circuit de protection Réglage des commandes des foyers de surfaceCe bouton de commande est typique seulement Réglage Type de cuissonCasseroles et sous-plats particuliers Conseils et renseignements sur la mise en conservePour ne pas endommager la surface de cuisson Voyants lumineux Circulation d’air dans le four Rôtissage par convection certains modèlesConseils sur la convection Instructions de cuisson générales Système de cuisson rapide certains modèlesLes avantages du système de cuisson rapide Réglage du système de cuisson rapideCuisson au gril Réglage du fourÉléments radiants réguliers certains modèles Surface de cuisson vitrocéramique certains modèlesTypes de foyers utilisés Éléments radiants à surface variable certains modèlesRéglage de la commande de la zone réchaud certains modèles Surface de cuisson vitrocéramique certains modèles suiteVoyant avertisseur de surface chaude certains modèles Entretien de la surface de cuisson Papier d’aluminiumRécipients en aluminium Problème Causes Pour prévenir Pour enleverNe pas utiliser sur la surface de cuisson vitrocéramique Entretien de la surface de cuisson suiteComment nettoyer la surface de cuisson vitrocéramique Pour l’enleverNettoyage extérieur Tableau des commandesNettoyage de l’appareil Modèles avec panneau de verrePour la saleté tenace et les taches calcinées Nettoyage de l’appareil suiteNettoyage quotidien Pour la saleté normale Pour les renversements sucrésNettoyage du four régulier four non autonettoyant Nettoyage du four autonettoyant certains modèlesPréparation du four avant l’autonettoyage Table de cuisson levable certains modèles Enlever et réinstaller la porteRéglage des commandes du four Ce qui peut survenir durant l’autonettoyagePorte avec vitre extérieure démontable certains modèles Retirer/replacer le tiroir de rangementRéglage des commandes du tiroir-réchaud Tiroir-Réchaudcertains modèles suite Disposition de la grille du tiroir-réchaudNettoyage général PlatAvant d’appeler un technicien de service lisez ce qui suit Liste des vérifications préventivesLA Cuisinière NE Fonctionne PAS Liste des vérifications préventives suite LA Cuisinière NE FonctionneSurface DE Cuisson Vitrocéramique certains Modèles Cuisson AU FourÉvitez d’endommager l’appareil durant son transport Cuisson AU GrilGarantie DE LA Cuisinière
Top Page Image Contents