Installation Instructions
INSTALL THE RANGE
8 REPLACE THE WIRE COVER
Replace the wire cover on the range back by sliding its right edge under the retaining tab and replacing the two screws removed earlier. Make sure that no wires are pinched between the cover and the range back.
2 screws to | Retaining |
replace wire | tab |
cover |
|
| Wire |
| cover |
Back of range
9 ANTI-TIP DEVICE INSTALLATION
An
Bracket | Wall plate |
Screw must enter wood or metal
Typical installation of
WARNING:
•Range must be secured by
•If the
•See instructions to install (supplied with bracket).
•Unless properly installed, the range could be tipped by stepping or sitting on the door. Injury may result from spilled hot liquids or from the range itself.
10 LEVEL THE RANGE
AInstall the oven racks in the oven and position the range where it will be installed.
BCheck for levelness by placing a spirit level or a
cup, partially filled with water, on one of the oven
racks. If using a spirit level, take two
level placed diagonally first
in one direction and then the other.
CThe rear leveling legs must be adjusted prior to moving the range into position. They can be adjusted from the bottom at the back of the range.
Adjust from |
|
the bottom back |
|
of range (warming | Raise |
drawer models) | range |
Leg leveler
Lower range
Back of range
DUse an
EReplace the drawer or panel.
46