Installation Manual
ENGLISH
Conversion for LP or NG Gas
Converting Appliance for Use with LP Gas
WARNING
Conversion is to be performed by a AUTHOR- IZED SERVICER (or other qualified agency) in accordance with the manufacturer's instructions and all codes and requirements of the authority having jurisdiction. Failure to follow instructions could result in serious injury or property damage. The qualified agency performing this work as- sumes responsibility for this conversion.
WARNING
Electrical power and gas must be turned off prior to conversion.
If this appliance should be converted for use with gas LP (propane or butane), each of the following modifi- cation must be performed:
Replace injector on (one ring flame burners)
1.Remove the grates and burner cups.
2.Remove aluminum gas spreader.
3.Loosen injector by turning
4.Install the injectors supplied with this appliances in the appropriate burner. The injectors have small number stamped on the side, this number codes the orifice diameter and its correct burner location (see figure on page 18).
5.Turn clockwise to tighten (tighten to a torque of 15 to 20
6.Replace all parts following the reverse order.
7.Save the orifices removed from the appliance for future use.
Figure 17. |
16