TROUBLESHOOTING
TROUBLESHOOTING | SEZ SERIES COUNTERTOP STEAMERS |
Figure 7
Voltage Check at Control Panel Fuse Block
Control Panel
Fuse Block
Door Switch
Terminal |
|
Block | Power Switch |
“ON” Light
“SERVICE REQUEST” Light
1.DISCONNECT POWER AT CIRCUIT BREAKER.
2.Remove control panel without disconnecting plug.
3.Turn lever to “ON” position.
4.Reconnect power.
5.Place leads as shown for test being performed.
6.Check that the voltage is in the range 200 to 240 volts.
PAGE 24 | OPERATOR’S MANUAL 1183437 |