4 HAULER INFORMATION
HAULER INSTRUCTIONS - HYDRAULIC TAILGATE OPERATION |
|
(FOR OPTIONAL HT UNITS) |
The truck hoist must have a hydraulic selector valve with 1500 psi, min. to operate the hydraulic tailgate. The hydraulic tailgate is supplied with one 1/2” NPTF male quick dis- connect mounted on the drivers side of the unit. A 1/2” female quick disconnect is sup- plied for use on the truck hoist valve plumbing.
CAUTION
*STAND CLEAR OF TAILGATE WHEN LIFTED.
*TRUCK MUST BE ON FIRM, LEVEL SURFACE BEFORE LIFTING TAILGATE.
*FRONT AND REAR HOLD DOWNS MUST BE ENGAGED.
*TILT HOIST BEFORE LIFTING TAILGATE.
1.ATTACH HYDRAULIC CONNECTION.
2.DISENGAGE LATCH. (EACH SIDE)
CONTAINER/COMPACTOR |
DANGER |
STAND CLEAR OF
TAILGATE
WHEN LIFTED
LATCH
TRUCK HOIST
3.RAISE HOIST.
4.LIFT TAILGATE.
5.EMPTY CONTENTS.
TAILGATE
TRUCK HOIST
CONTENTS
6.CLEAN SEAL AS DESCRIBED IN THE “HAULER INSTRUCTIONS - GENERAL” IN THIS SECTION OF THE MANUAL. NOTE WARNINGS.
7.LOWER TAILGATE AS LOW AS POSSIBLE.
8.LOWER HOIST.
9.LOWER TAILGATE COMPLETELY.
10.ENGAGE AND TIGHTEN LATCHES.
11.REMOVE HYDRAULIC CONNECTION.