Marathon RJ-88SC, RJ-100SC, RJ-250SC installation manual Operating Instructions for RJ-250VL

Page 8

1 OPERATION

OPERATING INSTRUCTIONS FOR RJ-250VL

1-6

 

 

1. First, place the material to be discarded into the compactor.

Note: If you are loading the compactor through a door or gate, close it before starting the compactor. Refer to “Optional Loading Configurations” in the Decal Placement section to determine how your compactor is set up.

2.Insert the key into the key switch. Turn it clockwise and release. The unit will make one complete cycle, then stop.

3.Repeat, if necessary, after the compactor has stopped.

4.When you have finished using the compactor, remove the key from the key switch.

IN CASE OF EMERGENCY:

Push the large red button to STOP

MANUAL OVERRIDE INSTRUCTIONS (RAM STOP REAR ONLY - RJ-250VL)

If the ram is stopped in any position:

-To move the ram forward, turn the key switch clockwise and release.

-To move the ram rearward, hold the reverse button down, turn and release the key switch, then release the reverse button.

While the ram is moving:

- To reverse the ram while it is moving forward, press the reverse but- ton.

-To cause the ram to move forward while it is moving rearward, turn and release the key switch.

NOTE: Refer to Optional Controls for Manual Override on Ram Stop Forward Machines.

Image 8
Contents Play IT Safe Contents Operation IntroductionWastec SpecificationsSide View PRE-OPERATION Instructions Only Authorized Personnel Should be Allowed InsideKeyed Start Switch Reverse Operator StationEmergency Stop Control Description for 88SC, 100SC, & 250SC Control Description for 250VLCase of Emergency Operating Instructions for RJ-250VL Manual Override Instructions RAM Stop Rear only RJ-250VLOptional Controls Decals for RJ-88SC, RJ-100SC, RJ-250SC, or RJ-250VL Remote Power Unit Optional Loading Configurations Dock Access Gate & HopperTHRU-THE-WALL Security ChuteHydraulic Tailgate HT Units Rear ViewMaintenance LOCK-OUT & TAG-OUT InstructionsPeriodic Maintenance Procedures Pressure SettingPressure Settings Relief SettingRAM Control Timer Adjustment Printe D Circuit Board Locate D I N Motor Control PanelMULTI-CYCLE Timer Adjustment Option Warranty and Service on MotorsCylinder Removal Instructions RAM Stop Forward OptionStandard System Operating CHARACTERISTICS, 5 hp & 10 hp Principles of OperationTailgate Seal Replacement Front ViewDoor Seal on Door Section A-AFuses and Circuit Breakers ChartsTimer Settings Wire Sizes Length SizeParts List Part DescriptionMotor Control Panel Typical Power Unit Standard 5 HP Power Unit Standard 10 HP Hydraulic Schematic Typical TROUBLE-SHOOTING Chart Problem Cause SolutionPump Makes NOISE-SOUNDS Container Guides Concrete PAD RequirementsConcrete PAD Steel Installation Procedures Dock InstallationCHUTE-FED Installation DecalsElectrical & Hydraulic Installation Remote Power Pack InstallationSTART-UP Instructions Pushbutton Operator StationElectrical Connections TOP View Compactor THROUGH-THE-WALL Power Unit InstallationPower Unit Hauler Instructions General See the Next page for Door and Latch Operation InstructionsLatch Side View Container Hauler Instructions DOOR/LATCH OperationAuto Relatch For Optional HT Units Instructions for Using Maintenance BAR Body Between the Tailgate and the ContainerHauler Instructions Liquid Removal For Optional SL Units