Marathon RJ-250VL PRE-OPERATION Instructions, Only Authorized Personnel Should be Allowed Inside

Page 5

1 OPERATION

PRE-OPERATION INSTRUCTIONS

1-3

 

 

FEDERAL REGULATION PROHIBITS THE USE OF THIS

EQUIPMENT BY ANYONE UNDER 18 YEARS OF AGE.

STAY CLEAR OF ALL INTERNAL PARTS OF THE

SELF-CONTAINED COMPACTOR/CONTAINER

DURING OPERATION. FAILURE TO DO SO

COULD RESULT IN SERIOUS INJURY OR DEATH!

NEVER ENTER ANY PART OF THE COMPACTOR UNLESS THE DISCON- NECT SWITCH HAS BEEN LOCKED-OUT AND TAGGED-OUT. See Lock- Out & Tag-Out instructions in the Maintenance section. Before starting the compactor, be sure no one is inside. Be certain that everyone is clear of all points of operation and pinch point areas before starting.

THE EMPLOYER SHOULD ALLOW ONLY AUTHO- RIZED AND TRAINED PERSONNEL TO OPERATE THIS COMPACTOR. This compactor is equipped with a key operated locking system. The key(s) should be in the possession of only authorized personnel.

DO NOT REMOVE ACCESS COVERS EXCEPT FOR SERVICING. Only authorized service personnel should be allowed inside. All access doors on the compactor body should always be secured in place when the unit is operating. See Lock-Out & Tag-

Out instructions in the Maintenance section.

ONLY AUTHORIZED PERSONNEL

SHOULD BE ALLOWED INSIDE THE

MOTOR CONTROL PANEL. The motor

control panel contains high voltage compo-

nents. See Lock-Out & Tag-Out

Instructions in the Maintenance sec- tion.

If the compactor is equipped with a security gate or doghouse with security door, BE

SURE THAT THE SECURITY GATE OR DOOR IS CLOSED BEFORE THE COM- PACTOR IS STARTED.

Image 5
Contents Play IT Safe Contents Introduction OperationWastec SpecificationsSide View Only Authorized Personnel Should be Allowed Inside PRE-OPERATION InstructionsOperator Station Keyed Start Switch ReverseEmergency Stop Control Description for 88SC, 100SC, & 250SC Control Description for 250VLCase of Emergency Manual Override Instructions RAM Stop Rear only RJ-250VL Operating Instructions for RJ-250VLOptional Controls Decals for RJ-88SC, RJ-100SC, RJ-250SC, or RJ-250VL Remote Power Unit Dock Access Gate & Hopper Optional Loading ConfigurationsTHRU-THE-WALL Security ChuteRear View Hydraulic Tailgate HT UnitsLOCK-OUT & TAG-OUT Instructions MaintenancePeriodic Maintenance Pressure Setting ProceduresPressure Settings Relief SettingPrinte D Circuit Board Locate D I N Motor Control Panel RAM Control Timer AdjustmentWarranty and Service on Motors MULTI-CYCLE Timer Adjustment OptionCylinder Removal Instructions RAM Stop Forward OptionPrinciples of Operation Standard System Operating CHARACTERISTICS, 5 hp & 10 hpFront View Tailgate Seal ReplacementDoor Seal on Door Section A-AFuses and Circuit Breakers ChartsTimer Settings Length Size Wire SizesPart Description Parts ListMotor Control Panel Typical Power Unit Standard 5 HP Power Unit Standard 10 HP Hydraulic Schematic Typical Problem Cause Solution TROUBLE-SHOOTING ChartPump Makes NOISE-SOUNDS Container Guides Concrete PAD RequirementsConcrete PAD Dock Installation Steel Installation ProceduresCHUTE-FED Installation DecalsRemote Power Pack Installation Electrical & Hydraulic InstallationSTART-UP Instructions Pushbutton Operator StationElectrical Connections TOP View Compactor THROUGH-THE-WALL Power Unit InstallationPower Unit See the Next page for Door and Latch Operation Instructions Hauler Instructions GeneralLatch Side View Container Hauler Instructions DOOR/LATCH OperationAuto Relatch For Optional HT Units Body Between the Tailgate and the Container Instructions for Using Maintenance BARHauler Instructions Liquid Removal For Optional SL Units