Marathon RJ-100SC, RJ-88SC, RJ-250VL, RJ-250SC Body Between the Tailgate and the Container

Page 38

4 HAULER INFORMATION

HAULER INSTRUCTIONS - HYDRAULIC TAILGATE OPERATION

 

(FOR OPTIONAL HT UNITS)

4-4

WARNING: NEVER PLACE ANY PART OF YOUR

BODY BETWEEN THE TAILGATE AND THE CONTAINER.

INSTRUCTIONS FOR USING MAINTENANCE BAR.

1.Lower tailgate approximately 24” between container bottom and compactor tailgate.

2Remove locking pin from maintenance bar and slide bar toward compactor.

3.Align holes in the position collar and bar and insert pin.

4.Use a mop or similar cleaning device with a long handle to clean the seal.

5.Raise tailgate to relieve pressure on maintenance bar, remove pin, return bar to retracted position and insert pin through collar and bar.

 

EXPLODED VIEW

EXTENDED

DRAWING A

MAINTENANCE BAR

DRAWING A

 

LOCKING PIN

 

POSITION

 

COLLAR

EXPLODED VIEW

DRAWING B

RETRACTED

DRAWING B

MAINTENANCE BAR

 

LOCKING PIN

POSITION

COLLAR

Image 38
Contents Play IT Safe Contents Operation IntroductionWastec SpecificationsSide View PRE-OPERATION Instructions Only Authorized Personnel Should be Allowed InsideEmergency Stop Control Description for 88SC, 100SC, & 250SC Keyed Start Switch ReverseOperator Station Control Description for 250VLCase of Emergency Operating Instructions for RJ-250VL Manual Override Instructions RAM Stop Rear only RJ-250VLOptional Controls Decals for RJ-88SC, RJ-100SC, RJ-250SC, or RJ-250VL Remote Power Unit THRU-THE-WALL Optional Loading ConfigurationsDock Access Gate & Hopper Security ChuteHydraulic Tailgate HT Units Rear ViewMaintenance LOCK-OUT & TAG-OUT InstructionsPeriodic Maintenance Pressure Settings Relief ProceduresPressure Setting SettingRAM Control Timer Adjustment Printe D Circuit Board Locate D I N Motor Control PanelCylinder Removal Instructions MULTI-CYCLE Timer Adjustment OptionWarranty and Service on Motors RAM Stop Forward OptionStandard System Operating CHARACTERISTICS, 5 hp & 10 hp Principles of OperationDoor Seal on Door Tailgate Seal ReplacementFront View Section A-AFuses and Circuit Breakers ChartsTimer Settings Wire Sizes Length SizeParts List Part DescriptionMotor Control Panel Typical Power Unit Standard 5 HP Power Unit Standard 10 HP Hydraulic Schematic Typical TROUBLE-SHOOTING Chart Problem Cause SolutionPump Makes NOISE-SOUNDS Container Guides Concrete PAD RequirementsConcrete PAD CHUTE-FED Installation Steel Installation ProceduresDock Installation DecalsElectrical & Hydraulic Installation Remote Power Pack InstallationSTART-UP Instructions Pushbutton Operator StationElectrical Connections TOP View Compactor THROUGH-THE-WALL Power Unit InstallationPower Unit Hauler Instructions General See the Next page for Door and Latch Operation InstructionsLatch Side View Container Hauler Instructions DOOR/LATCH OperationAuto Relatch For Optional HT Units Instructions for Using Maintenance BAR Body Between the Tailgate and the ContainerHauler Instructions Liquid Removal For Optional SL Units