Rotel RCD-06 Troubleshooting, Specifications, Power Indicator Is Not Lit, Fuse Replacement

Page 9

9

English

Troubleshooting

Most difficulties in audio systems are the result of incorrect connections, or improper control settings. If you encounter problems, isolate the area of the difficulty, check the control settings, determine the cause of the fault and make the necessary changes. If you are unable to get sound from the RCD-06, refer to the sugges- tions for the following conditions:

Power Indicator Is Not Lit

The Power Indicator and the basic items in the Display window should be lit whenever the RCD-06 is plugged into the wall power outlet and the Power button is pushed in. If it does not light, test the power outlet with another electrical device, such as a lamp. Be sure the power outlet being used is not controlled by a switch that has been turned off.

Fuse Replacement

If another electrical device works when plugged into the power outlet, but the Power Indica- tor and the Display still will not light when the RCD-06 is plugged into the wall outlet, it indicates that the internal power fuse may have blown. If you believe this has happened, contact your authorized Rotel dealer to get the fuse replaced.

No Sound

Check the cables between the RCD-06 and the amplifier inputs to be sure they are connected properly. Be sure the correct amplifier input is selected. Be sure the tape monitor system of the amplifier has not been activated. Check the wiring between the amplifer and the speakers.

Specifications

Total Harmonic Distortion + Noise

0.0045% @ 1kHz

Intermodulation Distortion

0.0045% @ 1kHz

Frequency Response (± 0.5 dB)

20-20,000 Hz

Channel Balance

± 0.5 dB

Phase Linearity

± 0.5 degree

Channel Separation

> 98 dB @ 1kHz

Signal to Noise Ratio

> 100dB

Dynamic Range

> 96 dB

Digital to Analog Converters

Enhanced, multi-level Delta-Sigma DAC

 

8x oversampling digital filter

Speed Accuracy, Wow & Flutter

Quartz Crystal Precision

Output Impedance

100 Ohms

Digital Output

0.5 Volt, Peak to Peak

Load Impedance

75 Ohms

Power Requirements

 

USA Version

AC 120V, 60 Hz

European Version

AC 230V, 50 Hz

Power Consumption

20 Watts

Dimensions (W, H, D)

171/8 x 27/8 x 125/16 inches

 

437 x 73 x 313 mm

Panel Height

60 mm / 23/8”

Weight (net)

5 kg, 11 lb.

All specifications are accurate at the time of printing.

Rotel reserves the right to make improvements without notice.

Rotel and the Rotel HiFi logo are registered trademarks of The Rotel Co, Ltd., Tokyo, Japan.

Image 9
Contents RCD-06 For Laser Products Important Safety InstructionsОрганы управления и разъемы Аналоговые выходы Contents About RotelGetting Started Operation AC Power and ControlAdditional Features 12V Trigger Connection q External Remote Input wPower Indicator Is Not Lit TroubleshootingFuse Replacement SpecificationsInstructions importantes concernant la sécurité Sommaire Au sujet de Rotel Identification des commandesPour démarrer Quelques précautionsFonctionnement Mise sous tensionFonctions additionnelles Commandes du transport du disqueEntrée pour télécommande externe w Remplacement du fusible ’indicateur Power de mise sous tension ne s’allume pasSpécifications Problèmes de fonctionnementWichtige Sicherheitshinweise Die Firma Rotel InhaltsverzeichnisZu dieser Anleitung Netzspannung und Bedienung BetriebAusgangsanschlüsse Weitere Features 12V TRIG-Eingang q Bei Störungen Die POWER-LED leuchtet nichtTechnische Daten Austauschen der SicherungImportanti instruzioni di Sicurezza Per Cominciare IndiceAlcune Precauzioni PosizionamentoComandi FunzionamentoCollegamenti In Uscita Altre Caratteristiche Tasto Clear H Tasto ReviewTasto Random D Tasto Repeat CIl LED indicatore Power non sia accende Risoluzione dei problemiCaratteristiche Sostituzione del FusibileRelacionadas con la Seguridad Instrucciones ImportantesPara Empezar Contenido Acerca de RotelAlgunas Precauciones ColocaciónFuncionamiento Conexiones de SalidaAlimentación y Control Bandeja de Transporte Teclas Direct Access BTecla OPEN/CLOSE 6A Tecla Play 7MTecla Review solo desde el mando a distancia Tecla Program JTecla Clear H Tecla Random DEntrada para Control Remoto Externo w Problemas y Posibles SolucionesEl Indicador Luminoso de Puesta en Marcha No Se Activa Sustitución del FusibleWaarschuwing Een paar voorzorgsmaatregelen Inhoud Wij van RotelEen plek voor de RCD-06 De ronde en vierkante hokjesDe Bediening Het aansluiten op het lichtnetHet aansluiten van de uitgangen De toetsen voor de afspeelfuncties De verwijdertoets Clear H De controletoets REVDe husseltoets Random D De herhaaltoets Repeat CDe lichtnetindicator werkt niet Wat te doen bij problemen?De 12V Trigger aansluiting q Het vervangen van de zekeringViktig säkerhetsinstruktion Introduktion Om RotelAtt tänka på PlaceringAnvändning UtgångarGrundfunktioner Ström och strömfunktionerrPausa en skiva 9N Stoppa skivan 8FHoppa framåt/bakåt 0L Direktknappar BFelsökning Volts styrsignaler qSpecifikationer Важные инструкции по безопасности Компании Rotel Первые шагиОсновные операции См. рисНее Цифровые кнопки, помеченные от 1 до Только на пультеНомер выбранной дорожки отображается на дисплее После ввода программы RCD-06 остается12-В триггерный вход q External Remote wЕсли другой электроприбор, подключенный Диагностика и устранение неполадокUSA

RCD-06 specifications

The Rotel RCD-06 is a high-performance CD player designed for audiophiles seeking a blend of exceptional sound quality and robust build. This device is part of Rotel's prestigious line of audio equipment, known for its commitment to delivering superior audio performance.

One of the standout features of the RCD-06 is its high-quality digital-to-analog converter (DAC). Rotel employs a precision Wolfson WM8740 DAC which ensures that digital signals are converted into analog sounds with remarkable fidelity. This component is pivotal for reproducing the full spectrum of audio, allowing listeners to enjoy music in all its intricacies and richness.

The RCD-06 also showcases Rotel's proprietary audio technology, including a dedicated power supply that isolates digital and analog sections. This design minimizes interference and cross-talk between the two, resulting in cleaner sound reproduction. The build quality of the RCD-06 reflects Rotel's dedication to craftsmanship, featuring a sturdy chassis that reduces vibrations and enhances overall durability.

For user convenience, the Rotel RCD-06 is equipped with an intuitive front panel, offering direct access to essential functions. The remote control simplifies operation, letting users easily navigate through their CD collection. It also includes features such as a programmable play mode to customize playback sequences, along with support for various CD formats.

In terms of connectivity, the RCD-06 comes with both analog and digital outputs, allowing for flexibility in integration within different audio setups. The optical and coaxial digital outputs enable connection to external DACs and processors, maximizing versatility. Moreover, the player supports standard CD formats, ensuring compatibility with most music collections.

Another notable aspect of the Rotel RCD-06 is its elegant design. Combining sleek aesthetics with practical functionality, the player’s front display is easy to read, displaying track information clearly. Available in a brushed aluminum finish, it complements any high-end audio system beautifully.

In summary, the Rotel RCD-06 stands out for its sophisticated sound technologies, precision engineering, and user-friendly features. It is ideally suited for those looking to elevate their music listening experience through a blend of timeless design and cutting-edge audio performance. Whether used as a standalone player or as part of a more extensive audio system, the RCD-06 is a testament to Rotel's legacy in high-fidelity sound reproduction.