Turbo Chef Technologies Tornado Error Codes/Faults, Possible Causes and Suggested Remedies

MAINTENANCE AND TROUBLESHOOTING 27

Table 1: Error Codes/Faults, Possible Causes and Suggested Remedies

The following is a list of fault codes and error messages, along with the possible problem(s) that the oven may be experiencing. Please attempt the recommended action before calling Customer Service.

NOTE: Any fault codes listed in bold will terminate a cook cycle upon discovery. F6 will not terminate a cook cycle; however, it will alert the user of a possible air circulation problem.

I S S U E	POSSIBLE CAUSE(S)	RESOLUTION
No power to oven.	† Oven is not plugged in.	† Plug oven in.
	† Main circuit breaker is tripped.	† Verify wall circuit breaker is on.
		Reset breaker and then power oven
		back on.
Oven is not warming	† Oven is in OFF state.	† Press the OVEN ON soft key.
up properly.	† Door is not closed.	† Close the cook cavity door.
	† Oven has been switched off at	† Press the BACK key until the oven
	the main circuit breaker.	is in the OFF state – leave for two (2)
		minutes. Unplug the oven – leave for
		two (2) minutes. Re-plug in the oven,
		switch on the isolator/main power
		supply, and press the OVEN ON soft
		key.
Display reads	† Oven door is open.	† Open and close the door several times.
“Oven Door Open”	† Door switches are out of	† Call Customer Service.*
and alarm sounds.	alignment.
Oven is not	† Oven is not clean. (Large	† Clean the oven following the cleaning
cooking properly.	deposits of grease, carbon, or	instructions on page 25.
	food debris dilute the
	microwave.)
	† Incorrect Group and/or	† Check to make sure correct food
	Item name was selected for	group and/or item was selected for the
	the product.	product being cooked.
	† Product was not cooked from	† Ensure product was in the correct
	correct starting state (for	state before being placed in the oven.
	example, chilled or frozen).

*For Customer Service, call 800.90TURBO/+1 214-379-6000 or your Authorized Distributor.