Makita EG781AE, EG301A, EG711AE, EG381AE, EG511AE manual Disassembly, － 29－

Page 34

Brush Maintenance Essentials (Disassembly and Assembly)

ENGLISH

Disassembly

1.Remove the two flange bolts (M5 x 20), then remove the bracket cover.

2.Remove the two flange bolts (M5 x 16), then remove the brush.

Assembly

1.While pressing the brush against the slip ring, secure it (1.5~2N・m) by tightening it with the two flange bolts (M5 x 16).

When doing so, confirm that the brush is in the proper position relative to the slip ring.

2.Secure the bracket cover (3~4N・m) by tightening it with the two flange bolts (M5 x 20).

Brush

Slip ring

Brush holder

Flange bolts

Bracket cover

Flange bolts

－ 29－

Image 34

Contents EG series AIR Index Page Foreword ［CAUTION］Contents Safety Precautions － 1－－ 2－ Specifications － 3－Components － 4－EG711A, EG711AE, EG781A, EG781AE － 5－－ 6－ Check Engine OIL PRE-OPERATION Checks－ 7－ Up to Level position Check Engine Fuel－ 8－ Check Generator Surroundings Checking Component Parts－ 9－ To positive + terminal Grounding GeneratorCable first － 10－Starting the Generator Operating Procedures－ 11－ Recoil starter model Electric starter model－ 13－ Using Electric Power － 14－To take power out from the Twist － 15－Gfci Receptacle － 16－Full Power Switch Except EG301A － 17－Connection of exclusive DC cable Only for charging 12 volt batteryDC Circuit Breaker － 18－Battery Charging Procedures － 19－［Recoil starter model］ Stopping the GeneratorOIL Sensor ［Electric starter model］Wattage Information － 21－Voltage Drop in Electric Extension Cords － 22－Spark Arrester － 23－Daily Inspection Maintenance SchedulePeriodic Maintenance － 24－Periodic Maintenance Schedule table － 25－Engine OIL Change HOW-TO MaintenanceServicing the AIR Cleaner － 26－Cleaning Fuel Strainer Cleaning and Adjusting Spark Plug－ 27－ Checking Carbon Brush － 28－Disassembly － 29－Preparation for Storage － 30－When No Electricity Is Generated at Receptacle TroubleshootingWhen Engine Fails to Start － 31－EG301A 60Hz-120V Wiring Diagram－ 32－ EG381A 60Hz-120/240V － 33－EG381AE 60Hz-120/240V Grn/Y Earth Ground terminalEG511A, EG711A, EG781A 60Hz-120/240V － 35－EG511AE, EG711AE, EG781AE 60Hz-120/240V － 36－Makita Corporation