Makita EG301A, EG781A, EG711AE, EG511A, EG381AE manual To take power out from the Twist, - 15-

Page 20

Style

Ampere Receptacle

AC plug

Description

 

 

NEMA

NEMA

GFCI (Ground Fault

 

up to 20A

Circuit Interrupter)

 

5-20R

5-20P

Receptacle, duplex

 

 

 

 

 

 

(REC1)

 

up to 30A

NEMA

NEMA

Locking Receptacle

 

L5-30R

L5-30P

(REC3)

 

 

 

up to 30A

NEMA

NEMA

Locking Receptacle

 

L14-30R

L14-30P

(REC4)

 

 

TABLE 1

WARNING

 

To take power out from the TWIST

TWIST

LOCK RECEPTACLE, insert the

 

plug into the receptacle, and turn

 

it clockwise to the lock position.

 

Be sure to ground the generator if the connected electrical device Is

grounded.

NOTE :

When the AC circuit breaker turns off during operation, the generator is over loaded or the appliance is defective. Stop the generator immediately, check the appliance and / or generator for overloading or detect and have repaired as necessary by Makita factory or authorized service center.

CAUTION

The duplex 120V receptacle is protected by a GFCI (Ground Fault Circuit Interrupter). GFCI shuts off the output current from the duplex 120V receptacle when a ground fault occurs in the generator or the appliance. Please note that other receptacles are not protected by GFCI.

ENGLISH

15

Image 20
Contents EG series AIR Index Page Foreword [CAUTION]Contents Safety Precautions - 1-- 2- Specifications - 3-Components - 4-EG711A, EG711AE, EG781A, EG781AE - 5-- 6- - 7- PRE-OPERATION ChecksCheck Engine OIL - 8- Check Engine FuelUp to Level position - 9- Checking Component PartsCheck Generator Surroundings Grounding Generator Cable firstTo positive + terminal - 10-- 11- Operating ProceduresStarting the Generator Recoil starter model Electric starter model- 13- Using Electric Power - 14-To take power out from the Twist - 15-Gfci Receptacle - 16-Full Power Switch Except EG301A - 17-Only for charging 12 volt battery DC Circuit BreakerConnection of exclusive DC cable - 18-Battery Charging Procedures - 19-Stopping the Generator OIL Sensor[Recoil starter model] [Electric starter model]Wattage Information - 21-Voltage Drop in Electric Extension Cords - 22-Spark Arrester - 23-Maintenance Schedule Periodic MaintenanceDaily Inspection - 24-Periodic Maintenance Schedule table - 25-HOW-TO Maintenance Servicing the AIR CleanerEngine OIL Change - 26-- 27- Cleaning and Adjusting Spark PlugCleaning Fuel Strainer Checking Carbon Brush - 28-Disassembly - 29-Preparation for Storage - 30-Troubleshooting When Engine Fails to StartWhen No Electricity Is Generated at Receptacle - 31-- 32- Wiring DiagramEG301A 60Hz-120V EG381A 60Hz-120/240V - 33-EG381AE 60Hz-120/240V Grn/Y Earth Ground terminalEG511A, EG711A, EG781A 60Hz-120/240V - 35-EG511AE, EG711AE, EG781AE 60Hz-120/240V - 36-Makita Corporation