Makita EG381AE, EG781A, EG711A Grounding Generator, Cable first, To positive + terminal, － 10－

Page 15

WARNING

Death, personal injury and/or property damage may occur unless instructions are followed carefully.

■Use battery of recommended capacity.

■Turn the starter switch to the "STOP" position when mounting or dismounting battery. When mounting battery, connect the positive (+) cable first and then the negative (-) cable to the battery. Be careful not to short battery cables. When dismounting battery, disconnect negative (-)

cable first.
RED CABLE	: To positive (+) terminal
BLACK CABLE	: To negative (-) terminal

■Should the connection be made in incorrect manner, the generator will be broken.

■Tighten bolts and nuts on terminals securely so they will not be loosened by vibration.

■Disconnect battery cables when charging battery.

GROUNDING THE

GENERATOR

■To ground the generator to the earth, connect the grounding lug of the generator to the grounding spike driven into the earth or to the conductor which has been already grounded to the earth.

■If such grounding conductor or grounding electrode is unavailable, connect the grounding lug of the generator to the grounding terminal of the using electric tool or appliance.

Grounding spike

－ 10－

Image 15

Contents EG series AIR Index Page ［CAUTION］ ForewordContents － 1－ Safety Precautions－ 2－－ 3－ Specifications－ 4－ Components－ 5－ EG711A, EG711AE, EG781A, EG781AE－ 6－ PRE-OPERATION Checks Check Engine OIL－ 7－ Check Engine Fuel Up to Level position－ 8－ Checking Component Parts Check Generator Surroundings－ 9－－ 10－ Grounding GeneratorCable first To positive + terminalOperating Procedures Starting the Generator－ 11－ Electric starter model Recoil starter model－ 13－－ 14－ Using Electric Power－ 15－ To take power out from the Twist－ 16－ Gfci Receptacle－ 17－ Full Power Switch Except EG301A－ 18－ Only for charging 12 volt batteryDC Circuit Breaker Connection of exclusive DC cable－ 19－ Battery Charging Procedures［Electric starter model］ Stopping the GeneratorOIL Sensor ［Recoil starter model］－ 21－ Wattage Information－ 22－ Voltage Drop in Electric Extension Cords－ 23－ Spark Arrester－ 24－ Maintenance SchedulePeriodic Maintenance Daily Inspection－ 25－ Periodic Maintenance Schedule table－ 26－ HOW-TO MaintenanceServicing the AIR Cleaner Engine OIL ChangeCleaning and Adjusting Spark Plug Cleaning Fuel Strainer－ 27－－ 28－ Checking Carbon Brush－ 29－ Disassembly－ 30－ Preparation for Storage－ 31－ TroubleshootingWhen Engine Fails to Start When No Electricity Is Generated at ReceptacleWiring Diagram EG301A 60Hz-120V－ 32－－ 33－ EG381A 60Hz-120/240VGrn/Y Earth Ground terminal EG381AE 60Hz-120/240V－ 35－ EG511A, EG711A, EG781A 60Hz-120/240V－ 36－ EG511AE, EG711AE, EG781AE 60Hz-120/240VMakita Corporation