11. TROUBLESHOOTING
When generator engine fails to start after several attempts, or if no electricity is available at the output socket, check the following chart. If your generator still fails to start or generate electricity, contact your nearest Makita factory or authorized service center for further information or corrective procedures.
ENGLISH
When Engine Fails to Start :
Check if choke lever is in its proper position.
Check if fuel valve is open.
Check fuel level.
Check if engine switch is in OFF.
Check to make sure generator is not connected to an appliance.
Check spark plug for loose spark plug cap.
Set the choke lever to "CLOSE" position.
If closed, open fuel valve.
If empty, refill fuel tank making sure not to overfill.
Turn engine switch to ON.
If connected, turn off the power switch on the connected appliance and unplug.
If loose, push spark plug cap back into place.
Check spark plug for contamination. | Remove spark plug and clean electrode. |
When No Electricity Is Generated at Receptacle :
Check to make sure AC circuit breaker is in the "ON" position.
Check AC receptacle and DC terminals for loose connection.
Check to see if engine starting was attempted with appliances already connected to generator.
After making sure that the total wattage of the electrical appliance is within permissible limits and there are no defects in the appliance, turn the AC circuit breaker to the "ON" position.
If breakers continue to actuate, consult your nearest servicing dealer.
Secure connection if necessary.
Turn off switch on the appliance, and disconnect cable from receptacle. Reconnect after generator has been started properly.
Low power. | Carbon brushes are excessively worn |