Makita EG711AE, EG381AE, EG781AE, EG511AE manual Full Power Switch Except EG301A, － 17－

Page 22

FULL POWER SWITCH (Except EG301A)

Select the voltage using the FULL POWER SWITCH in accordance with the electrical appliance.

Refer to TABLE 2.

［CAUTION］

Change the FULL POWER SWITCH after turning the AC circuit breaker to "OFF".

120V

120V 240V

ENGLISH

Switch position

Lower Voltage Receptacle

Higher Voltage Receptacle

120V

Activated full rated output

N.A

120/240V

Activated half of rated output

Activated full rated output

TABLE 2

(1) CHECKING THE OPERATION

■Overloaded ?

Please make it sure that the generator is not overload.

NOTE :

Most induction loads such as electric motors require three to five times more wattage than their ratings during starting.

(2) STOPPING THE ENGINE

■Turn off the switch of load.

■Switch off generator's AC breaker.

■Disconnect tool or appliance.

■Turn the STOP SWITCH to the position "O" (OFF).

NOTE :

Allow the engine about 3 minutes to cool down at no-load before stopping.

－ 17－

Image 22

Contents EG series AIR Index Page Foreword ［CAUTION］Contents Safety Precautions － 1－－ 2－ Specifications － 3－Components － 4－EG711A, EG711AE, EG781A, EG781AE － 5－－ 6－ Check Engine OIL PRE-OPERATION Checks－ 7－ Up to Level position Check Engine Fuel－ 8－ Check Generator Surroundings Checking Component Parts－ 9－ To positive + terminal Grounding GeneratorCable first － 10－Starting the Generator Operating Procedures－ 11－ Recoil starter model Electric starter model－ 13－ Using Electric Power － 14－To take power out from the Twist － 15－Gfci Receptacle － 16－Full Power Switch Except EG301A － 17－Connection of exclusive DC cable Only for charging 12 volt batteryDC Circuit Breaker － 18－Battery Charging Procedures － 19－［Recoil starter model］ Stopping the GeneratorOIL Sensor ［Electric starter model］Wattage Information － 21－Voltage Drop in Electric Extension Cords － 22－Spark Arrester － 23－Daily Inspection Maintenance SchedulePeriodic Maintenance － 24－Periodic Maintenance Schedule table － 25－Engine OIL Change HOW-TO MaintenanceServicing the AIR Cleaner － 26－Cleaning Fuel Strainer Cleaning and Adjusting Spark Plug－ 27－ Checking Carbon Brush － 28－Disassembly － 29－Preparation for Storage － 30－When No Electricity Is Generated at Receptacle TroubleshootingWhen Engine Fails to Start － 31－EG301A 60Hz-120V Wiring Diagram－ 32－ EG381A 60Hz-120/240V － 33－EG381AE 60Hz-120/240V Grn/Y Earth Ground terminalEG511A, EG711A, EG781A 60Hz-120/240V － 35－EG511AE, EG711AE, EG781AE 60Hz-120/240V － 36－Makita Corporation