Makita EG511AE, EG781A, EG301A, EG381A, EG711AE manual Recoil starter model, Electric starter model

Page 17

(e)[Recoil starter model]

Pull the starter handle slowly until passing the compression point (resistance will be felt), then return the handle to its original position and pull briskly.

If the engine fails to start after several attempts, repeat above procedures with choke lever returned to "OPEN" position.

Do not fully pull out the rope.

After starting, allow the starter handle to return to its original position while still holding the handle.

(f)[Electric starter model]

Insert the key into the key switch and turn it clockwise to the "RUN" position to start the engine.

Then turn the key further to the "START" position. The engine will be started by starting motor.

Pull

briskly

 

STOP RUN

STOP

RUN

START

START

 

 

CAUTION

Do not run the starting motor over 5 seconds continuously.

If the engine fails to start, return the key to the "RUN" position and wait about 10 seconds then start again.

Do not turn the key switch to "START" position when the engine is running to prevent damage of starting motor.

When starting the engine by recoil starter, set the key switch at the "ON" position and pull the starter handle.

12

Image 17
Contents EG series AIR Index Page [CAUTION] ForewordContents - 1- Safety Precautions- 2- - 3- Specifications- 4- Components- 5- EG711A, EG711AE, EG781A, EG781AE- 6- - 7- PRE-OPERATION ChecksCheck Engine OIL - 8- Check Engine FuelUp to Level position - 9- Checking Component PartsCheck Generator Surroundings Cable first Grounding GeneratorTo positive + terminal - 10-- 11- Operating ProceduresStarting the Generator Electric starter model Recoil starter model- 13- - 14- Using Electric Power- 15- To take power out from the Twist- 16- Gfci Receptacle- 17- Full Power Switch Except EG301ADC Circuit Breaker Only for charging 12 volt batteryConnection of exclusive DC cable - 18-- 19- Battery Charging ProceduresOIL Sensor Stopping the Generator[Recoil starter model] [Electric starter model]- 21- Wattage Information- 22- Voltage Drop in Electric Extension Cords- 23- Spark ArresterPeriodic Maintenance Maintenance ScheduleDaily Inspection - 24-- 25- Periodic Maintenance Schedule tableServicing the AIR Cleaner HOW-TO MaintenanceEngine OIL Change - 26-- 27- Cleaning and Adjusting Spark PlugCleaning Fuel Strainer - 28- Checking Carbon Brush- 29- Disassembly- 30- Preparation for StorageWhen Engine Fails to Start TroubleshootingWhen No Electricity Is Generated at Receptacle - 31-- 32- Wiring DiagramEG301A 60Hz-120V - 33- EG381A 60Hz-120/240VGrn/Y Earth Ground terminal EG381AE 60Hz-120/240V- 35- EG511A, EG711A, EG781A 60Hz-120/240V- 36- EG511AE, EG711AE, EG781AE 60Hz-120/240VMakita Corporation