Topcon COMPUTERIZED TONOMETER, CT-80 instruction manual HOW to Connect the Power Cable

Page 15

HOW TO CONNECT THE POWER CABLE

	CAUTION	To avoid electrical shock, do not handle the power plug
		with wet fingers.

1	Make sure the POWER SWITCH is OFF.
2	Attach the power cable to the machine body.

3 Plug the power cable into the 3-pin AC receptacle with grounding.

HOW TO CONNECT EXTERNAL I/O TERMINALS

RS-232C OUT

This machine can be connected to another device, including a personal computer via the RS-232C OUT terminal.

1 Connect the cable to the RS-232C OUT terminal of this machine.

2 Connect the other cable end to another device.

RS-232C INOutput terminal Input terminal

This machine can be connected to another device, including a bar code reader via the RS-232C IN terminal.

1 Connect the cable to the RS-232C IN terminal of this machine.

2 Connect the other cable end to the external device.

14

PREPARATIONS

Image 15

Contents CT-80 Introduction This instrument features the followingDisplay Meaning Display for Safe USEIcons Prevention item Safety CautionsIcon Prevention item Safety CautionsPurpose Usage and MaintenanceUser Maintenance Escape ClausePage Names of Components ContentMain Body Components ComponentsAuto/Manual switch Air check switchControl Panel Components Monitor Screen Components Measurement Screen Auto mode, alignmentMeasurement Screen Manual mode, alignment OK Menu Screen Contents of Printer Output Standard Accessories Preparations HOW to Install the InstrumentHOW to Connect External I/O Terminals HOW to Connect the Power CableDisplaying The Menu Screen Initial SettingsMemo PreparationsTime/Date Setting Setting The Power Save Time RS-232C INPUT/OUTPUT Settings OFF ↔ MODE1 ↔ MODE2 ↔ MODE3 ↔ MODE4 ↔ Setting The Average Value Mode Setting The Buzzer Message Input Back HOW to SET Printer PaperAuto Setting StepPreparations TF50KS-E2C Manual Setting Preparations HOW to Reset from Power Save Status Air Check Turn on the PowerBasic Operations Preparations Before MeasurementSetting the Patient Setting the Safety Stopper ∼10mm Auto Measurement Under Auto Mode MemoSetting the Measurement Mode Setting the Measuring RangeAlignment and Measurement Basic Operations Basic Operations Manual mode. Sometimes Auto mode is not available if Manu Measurement Under Manual Mode MemoDisplay of Measurement Values ERR OverBasic Operations Alignment is adjusted correctly. Sometimes the shape Deleting Measurement Values Individual Operations HOW to Print OUT Measurement ValuesHOW to Correct Measurement Values INPUT/OUTPUT VIA RS-232C Output via RS-232CInput via RS-232C Before Requesting Service Checking OperationsChecking Operations Automatic instrument table AIT-20 and Table Board Optional AccessoriesSpecifications & Performance ReferenceRS-232C Communication Specifications Connector TypesTerminal Pin Arrangement Transmission Formula Contents of Data TransmissionReference Work ID no Setting RS-232C Communication ConditionsFormat Maintenance and Checking Accuracy MaintenanceCleaning the Measuring Window Glass Cleaning the Window Glass inside the Nozzle Daily Maintenance Adjusting the Monitor ScreenOrdering Consumable Supplies Replacing the Fuse Paper Jam in PrinterCleaning the Outer Cover Special Notes on CleaningComputerized Tonometer CT-80 Topcon Omni SYSTEMS, INC Computerized Tonometer