Topcon CT-80, COMPUTERIZED TONOMETER HOW to SET Printer Paper, Step, Back, Auto Setting

Page 24

4

5

■: A space for 1 character (Use this to delete a character, too.)

STEP	: The blinking icon of the input column moves right.
BACK	: The blinking icon of the input column moves left.

Press MEASUREMENT SWITCH .

The character selected by the blinking icon is inputted.

Press , , , on the control panel, move the blinking icon in the selection column to “EXIT” and press MEASUREMENT SWITCH .

The Menu screen is displayed.

HOW TO SET PRINTER PAPER

Auto Setting

1 Press the printer cover with your thumb, slide it aside and remove.

When the right/left end is reached, the blinking icon goes down to the next line. A message can contain up to 3 lines, 20 characters per line.

Printer cover

23

PREPARATIONS

Image 24

Contents CT-80 This instrument features the following IntroductionDisplay for Safe USE Display MeaningSafety Cautions Icons Prevention itemSafety Cautions Icon Prevention itemUsage and Maintenance User MaintenanceEscape Clause PurposePage Content Names of ComponentsComponents Main Body ComponentsAuto/Manual switch Air check switchControl Panel Components Monitor Screen Components Measurement Screen Auto mode, alignmentMeasurement Screen Manual mode, alignment OK Menu Screen Contents of Printer Output Standard Accessories HOW to Install the Instrument PreparationsHOW to Connect the Power Cable HOW to Connect External I/O TerminalsInitial Settings MemoPreparations Displaying The Menu ScreenTime/Date Setting Setting The Power Save Time RS-232C INPUT/OUTPUT Settings OFF ↔ MODE1 ↔ MODE2 ↔ MODE3 ↔ MODE4 ↔ Setting The Average Value Mode Setting The Buzzer Message Input HOW to SET Printer Paper Auto SettingStep BackPreparations TF50KS-E2C Manual Setting Preparations HOW to Reset from Power Save Status Turn on the Power Basic OperationsPreparations Before Measurement Air CheckSetting the Patient Setting the Safety Stopper ∼10mm Measurement Under Auto Mode Memo Setting the Measurement ModeSetting the Measuring Range AutoAlignment and Measurement Basic Operations Basic Operations Manual mode. Sometimes Auto mode is not available if Measurement Under Manual Mode Memo Display of Measurement ValuesERR Over ManuBasic Operations Alignment is adjusted correctly. Sometimes the shape Deleting Measurement Values HOW to Print OUT Measurement Values Individual OperationsHOW to Correct Measurement Values INPUT/OUTPUT VIA RS-232C Output via RS-232CInput via RS-232C Before Requesting Service Checking OperationsChecking Operations Optional Accessories Specifications & PerformanceReference Automatic instrument table AIT-20 and Table BoardRS-232C Communication Specifications Connector TypesTerminal Pin Arrangement Contents of Data Transmission Transmission FormulaReference Setting RS-232C Communication Conditions Work ID noFormat Maintenance and Checking Accuracy MaintenanceCleaning the Measuring Window Glass Cleaning the Window Glass inside the Nozzle Daily Maintenance Adjusting the Monitor ScreenOrdering Consumable Supplies Paper Jam in Printer Replacing the FuseSpecial Notes on Cleaning Cleaning the Outer CoverComputerized Tonometer CT-80 Computerized Tonometer Topcon Omni SYSTEMS, INC