Topcon COMPUTERIZED TONOMETER, CT-80 instruction manual HOW to Reset from Power Save Status

Page 29

8 Set the printer cover, holding the top of the paper outside.

If the paper is jammed, turn the paper retainer lever to the illustrated position, and take out the jammed paper from the printer.

HOW TO RESET FROM POWER SAVE STATUS

This machine employs a power save function. If the machine is not used during a set time, the power save function stops supplying power to the monitor and CCD camera. Under the power save status, the POWER lamp of the control panel flashes.

1 Press MEASUREMENT SWITCH .

The Monitor screen is displayed in a few seconds, when the measurements become available.

After resetting, the measurement mode is AUTO and the measuring range is 0-30. Also, values measured before power saving are deleted.

28

PREPARATIONS

Image 29

Contents CT-80 Introduction This instrument features the followingDisplay Meaning Display for Safe USEIcons Prevention item Safety CautionsIcon Prevention item Safety CautionsUser Maintenance Usage and MaintenanceEscape Clause PurposePage Names of Components ContentMain Body Components ComponentsControl Panel Components Auto/Manual switchAir check switch Measurement Screen Manual mode, alignment OK Menu Screen Monitor Screen ComponentsMeasurement Screen Auto mode, alignment Contents of Printer Output Standard Accessories Preparations HOW to Install the InstrumentHOW to Connect External I/O Terminals HOW to Connect the Power CableMemo Initial SettingsPreparations Displaying The Menu ScreenTime/Date Setting Setting The Power Save Time RS-232C INPUT/OUTPUT Settings OFF ↔ MODE1 ↔ MODE2 ↔ MODE3 ↔ MODE4 ↔ Setting The Average Value Mode Setting The Buzzer Message Input Auto Setting HOW to SET Printer PaperStep BackPreparations TF50KS-E2C Manual Setting Preparations HOW to Reset from Power Save Status Basic Operations Turn on the PowerPreparations Before Measurement Air CheckSetting the Patient Setting the Safety Stopper ∼10mm Setting the Measurement Mode Measurement Under Auto Mode MemoSetting the Measuring Range AutoAlignment and Measurement Basic Operations Basic Operations Manual mode. Sometimes Auto mode is not available if Display of Measurement Values Measurement Under Manual Mode MemoERR Over ManuBasic Operations Alignment is adjusted correctly. Sometimes the shape Deleting Measurement Values Individual Operations HOW to Print OUT Measurement ValuesHOW to Correct Measurement Values Input via RS-232C INPUT/OUTPUT VIA RS-232COutput via RS-232C Checking Operations Before Requesting ServiceChecking Operations Specifications & Performance Optional AccessoriesReference Automatic instrument table AIT-20 and Table BoardTerminal Pin Arrangement RS-232C Communication SpecificationsConnector Types Transmission Formula Contents of Data TransmissionReference Work ID no Setting RS-232C Communication ConditionsFormat Cleaning the Measuring Window Glass Maintenance and CheckingAccuracy Maintenance Cleaning the Window Glass inside the Nozzle Ordering Consumable Supplies Daily MaintenanceAdjusting the Monitor Screen Replacing the Fuse Paper Jam in PrinterCleaning the Outer Cover Special Notes on CleaningComputerized Tonometer CT-80 Topcon Omni SYSTEMS, INC Computerized Tonometer