Topcon COMPUTERIZED TONOMETER INPUT/OUTPUT VIA RS-232C, Output via RS-232C, Input via RS-232C

Page 45

INPUT/OUTPUT VIA RS-232C

Output via RS-232C

This machine can output data via the RS-232C interface to a personal computer or similar device.

1

Make sure the RS-232C OUT is connected.

 

For connection, see “HOW TO CONNECT EXTERNAL I/O TERMINALS” on page

2

14.

 

Check the settings for data communication.

3

For data communication, see “RS-232C Input/Output Settings” on page 18.

Obtain the measurements.

4

Press

on the control panel.

 

“RS-232C DATA OUT” is displayed on the screen and the data output is completed.

Input via RS-232C

This machine can input data from a bar code reader and the like via the RS-232C in- terface.

1 Make sure the RS-232C OUT is connected.

For connection, see “HOW TO CONNECT EXTERNAL I/O TERMINALS” on page 14.

2 Check the settings for data communication.

For data communication, see “RS-232C Input/Output Settings” on page 18.

3 Return to the Measurement screen.

4 Input the ID No. from the external device. The inputted “ID No.” is displayed.

44

INDIVIDUAL OPERATIONS

Image 45
Contents CT-80 Introduction This instrument features the followingDisplay Meaning Display for Safe USEIcons Prevention item Safety CautionsIcon Prevention item Safety CautionsUser Maintenance Usage and MaintenanceEscape Clause PurposePage Names of Components ContentMain Body Components ComponentsAuto/Manual switch Air check switchControl Panel Components Monitor Screen Components Measurement Screen Auto mode, alignmentMeasurement Screen Manual mode, alignment OK Menu Screen Contents of Printer Output Standard Accessories Preparations HOW to Install the InstrumentHOW to Connect External I/O Terminals HOW to Connect the Power CableMemo Initial SettingsPreparations Displaying The Menu ScreenTime/Date Setting Setting The Power Save Time RS-232C INPUT/OUTPUT Settings OFF ↔ MODE1 ↔ MODE2 ↔ MODE3 ↔ MODE4 ↔ Setting The Average Value Mode Setting The Buzzer Message Input Auto Setting HOW to SET Printer PaperStep BackPreparations TF50KS-E2C Manual Setting Preparations HOW to Reset from Power Save Status Basic Operations Turn on the PowerPreparations Before Measurement Air CheckSetting the Patient Setting the Safety Stopper ∼10mm Setting the Measurement Mode Measurement Under Auto Mode MemoSetting the Measuring Range AutoAlignment and Measurement Basic Operations Basic Operations Manual mode. Sometimes Auto mode is not available if Display of Measurement Values Measurement Under Manual Mode MemoERR Over ManuBasic Operations Alignment is adjusted correctly. Sometimes the shape Deleting Measurement Values Individual Operations HOW to Print OUT Measurement ValuesHOW to Correct Measurement Values INPUT/OUTPUT VIA RS-232C Output via RS-232CInput via RS-232C Before Requesting Service Checking OperationsChecking Operations Specifications & Performance Optional AccessoriesReference Automatic instrument table AIT-20 and Table BoardRS-232C Communication Specifications Connector TypesTerminal Pin Arrangement Transmission Formula Contents of Data TransmissionReference Work ID no Setting RS-232C Communication ConditionsFormat Maintenance and Checking Accuracy MaintenanceCleaning the Measuring Window Glass Cleaning the Window Glass inside the Nozzle Daily Maintenance Adjusting the Monitor ScreenOrdering Consumable Supplies Replacing the Fuse Paper Jam in PrinterCleaning the Outer Cover Special Notes on CleaningComputerized Tonometer CT-80 Topcon Omni SYSTEMS, INC Computerized Tonometer