Topcon COMPUTERIZED TONOMETER, CT-80 instruction manual Manual Setting

Page 27

Manual Setting

1 Press the printer cover with your thumb, slide it aside and remove.

2 Slide the paper roll onto the paper shaft, paying attention to the direction of unwind- ing, and pull out the top of the paper 7∼8cm.

3 Turn the paper retainer lever in the arrow direction.

4 Cut the paper on the control lever side at about 2cm. Paper retainer lever

Control lever

Cut here

26

PREPARATIONS

Image 27

Contents CT-80 Introduction This instrument features the followingDisplay Meaning Display for Safe USEIcons Prevention item Safety CautionsIcon Prevention item Safety CautionsPurpose Usage and MaintenanceUser Maintenance Escape ClausePage Names of Components ContentMain Body Components ComponentsAuto/Manual switch Air check switchControl Panel Components Monitor Screen Components Measurement Screen Auto mode, alignmentMeasurement Screen Manual mode, alignment OK Menu Screen Contents of Printer Output Standard Accessories Preparations HOW to Install the InstrumentHOW to Connect External I/O Terminals HOW to Connect the Power CableDisplaying The Menu Screen Initial SettingsMemo PreparationsTime/Date Setting Setting The Power Save Time RS-232C INPUT/OUTPUT Settings OFF ↔ MODE1 ↔ MODE2 ↔ MODE3 ↔ MODE4 ↔ Setting The Average Value Mode Setting The Buzzer Message Input Back HOW to SET Printer PaperAuto Setting StepPreparations TF50KS-E2C Manual Setting Preparations HOW to Reset from Power Save Status Air Check Turn on the PowerBasic Operations Preparations Before MeasurementSetting the Patient Setting the Safety Stopper ∼10mm Auto Measurement Under Auto Mode MemoSetting the Measurement Mode Setting the Measuring RangeAlignment and Measurement Basic Operations Basic Operations Manual mode. Sometimes Auto mode is not available if Manu Measurement Under Manual Mode MemoDisplay of Measurement Values ERR OverBasic Operations Alignment is adjusted correctly. Sometimes the shape Deleting Measurement Values Individual Operations HOW to Print OUT Measurement ValuesHOW to Correct Measurement Values INPUT/OUTPUT VIA RS-232C Output via RS-232CInput via RS-232C Before Requesting Service Checking OperationsChecking Operations Automatic instrument table AIT-20 and Table Board Optional AccessoriesSpecifications & Performance ReferenceRS-232C Communication Specifications Connector TypesTerminal Pin Arrangement Transmission Formula Contents of Data TransmissionReference Work ID no Setting RS-232C Communication ConditionsFormat Maintenance and Checking Accuracy MaintenanceCleaning the Measuring Window Glass Cleaning the Window Glass inside the Nozzle Daily Maintenance Adjusting the Monitor ScreenOrdering Consumable Supplies Replacing the Fuse Paper Jam in PrinterCleaning the Outer Cover Special Notes on CleaningComputerized Tonometer CT-80 Topcon Omni SYSTEMS, INC Computerized Tonometer