Topcon CT-80 instruction manual Initial Settings, Memo, Preparations, Displaying The Menu Screen

Page 16

INITIAL SETTINGS

During the initial setting, date, time, operating time of the power save function, RS- 232C, mode of average value, buzzer and message can be set.

Preparations

1 Make sure the power cable is connected.

For connection, see “HOW TO CONNECT THE POWER CABLE” on page 14.

2 Check the no-patient condition of the instrument and turn the POWER SWITCH ON.

•	When the machine is moved from a cold room to a warm room or
MEMO	when the room temperature suddenly rises, it may cause dewing in-
MEMO	side the machine and disable measurement. In this case, leave the
	machine alone for about 30min until it reaches room temperature.

Displaying The Menu Screen

1 Make sure that the Measurement screen is displayed.

2 Press on the control panel. The Menu screen is displayed.

Returning To The Measurement Screen

1 Press , on the control panel, move the cursor to “EXIT” and press

MEASUREMENT SWITCH .

Or, press on the control panel. The Measurement screen returns.

15

PREPARATIONS

Image 16

Contents CT-80 This instrument features the following IntroductionDisplay for Safe USE Display MeaningSafety Cautions Icons Prevention itemSafety Cautions Icon Prevention itemUsage and Maintenance User MaintenanceEscape Clause PurposePage Content Names of ComponentsComponents Main Body ComponentsAir check switch Auto/Manual switchControl Panel Components Measurement Screen Auto mode, alignment Monitor Screen ComponentsMeasurement Screen Manual mode, alignment OK Menu Screen Contents of Printer Output Standard Accessories HOW to Install the Instrument PreparationsHOW to Connect the Power Cable HOW to Connect External I/O TerminalsInitial Settings MemoPreparations Displaying The Menu ScreenTime/Date Setting Setting The Power Save Time RS-232C INPUT/OUTPUT Settings OFF ↔ MODE1 ↔ MODE2 ↔ MODE3 ↔ MODE4 ↔ Setting The Average Value Mode Setting The Buzzer Message Input HOW to SET Printer Paper Auto SettingStep BackPreparations TF50KS-E2C Manual Setting Preparations HOW to Reset from Power Save Status Turn on the Power Basic OperationsPreparations Before Measurement Air CheckSetting the Patient Setting the Safety Stopper ∼10mm Measurement Under Auto Mode Memo Setting the Measurement ModeSetting the Measuring Range AutoAlignment and Measurement Basic Operations Basic Operations Manual mode. Sometimes Auto mode is not available if Measurement Under Manual Mode Memo Display of Measurement ValuesERR Over ManuBasic Operations Alignment is adjusted correctly. Sometimes the shape Deleting Measurement Values HOW to Print OUT Measurement Values Individual OperationsHOW to Correct Measurement Values Output via RS-232C INPUT/OUTPUT VIA RS-232CInput via RS-232C Checking Operations Before Requesting ServiceChecking Operations Optional Accessories Specifications & PerformanceReference Automatic instrument table AIT-20 and Table BoardConnector Types RS-232C Communication SpecificationsTerminal Pin Arrangement Contents of Data Transmission Transmission FormulaReference Setting RS-232C Communication Conditions Work ID noFormat Accuracy Maintenance Maintenance and CheckingCleaning the Measuring Window Glass Cleaning the Window Glass inside the Nozzle Adjusting the Monitor Screen Daily MaintenanceOrdering Consumable Supplies Paper Jam in Printer Replacing the FuseSpecial Notes on Cleaning Cleaning the Outer CoverComputerized Tonometer CT-80 Computerized Tonometer Topcon Omni SYSTEMS, INC