Topcon COMPUTERIZED TONOMETER, CT-80 instruction manual Preparations

Page 25

2

3

Slide the paper roll onto the paper shaft, paying attention to the direction of unwind- ing, and pull out the top of the paper 7-8cm.

Unwinding direction

Insert

the

paper straight into the printer

along the paper guide.

4 When the top of the paper stops inside the printer, press to further insert the paper into the printer.

Paper feeding starts when the top of the paper reaches a certain depth inside the printer.

5 When the top of the paper comes out 1cm or so from the outlet, release . At this moment, hold the top of the paper firmly so that it is not rolled back.

6 Turn the paper retainer lever to the illustrated position, and pull out the paper 2-3cm so that it comes out straight from the outlet.

24

Paper retainer lever

 

PREPARATIONS

Image 25
Contents CT-80 Introduction This instrument features the followingDisplay Meaning Display for Safe USEIcons Prevention item Safety CautionsIcon Prevention item Safety CautionsUser Maintenance Usage and MaintenanceEscape Clause PurposePage Names of Components ContentMain Body Components ComponentsAir check switch Auto/Manual switchControl Panel Components Measurement Screen Auto mode, alignment Monitor Screen ComponentsMeasurement Screen Manual mode, alignment OK Menu Screen Contents of Printer Output Standard Accessories Preparations HOW to Install the InstrumentHOW to Connect External I/O Terminals HOW to Connect the Power CableMemo Initial SettingsPreparations Displaying The Menu ScreenTime/Date Setting Setting The Power Save Time RS-232C INPUT/OUTPUT Settings OFF ↔ MODE1 ↔ MODE2 ↔ MODE3 ↔ MODE4 ↔ Setting The Average Value Mode Setting The Buzzer Message Input Auto Setting HOW to SET Printer PaperStep BackPreparations TF50KS-E2C Manual Setting Preparations HOW to Reset from Power Save Status Basic Operations Turn on the PowerPreparations Before Measurement Air CheckSetting the Patient Setting the Safety Stopper ∼10mm Setting the Measurement Mode Measurement Under Auto Mode MemoSetting the Measuring Range AutoAlignment and Measurement Basic Operations Basic Operations Manual mode. Sometimes Auto mode is not available if Display of Measurement Values Measurement Under Manual Mode MemoERR Over ManuBasic Operations Alignment is adjusted correctly. Sometimes the shape Deleting Measurement Values Individual Operations HOW to Print OUT Measurement ValuesHOW to Correct Measurement Values Output via RS-232C INPUT/OUTPUT VIA RS-232CInput via RS-232C Checking Operations Before Requesting ServiceChecking Operations Specifications & Performance Optional AccessoriesReference Automatic instrument table AIT-20 and Table BoardConnector Types RS-232C Communication SpecificationsTerminal Pin Arrangement Transmission Formula Contents of Data TransmissionReference Work ID no Setting RS-232C Communication ConditionsFormat Accuracy Maintenance Maintenance and CheckingCleaning the Measuring Window Glass Cleaning the Window Glass inside the Nozzle Adjusting the Monitor Screen Daily MaintenanceOrdering Consumable Supplies Replacing the Fuse Paper Jam in PrinterCleaning the Outer Cover Special Notes on CleaningComputerized Tonometer CT-80 Topcon Omni SYSTEMS, INC Computerized Tonometer