Shindaiwa 89301, T3410/EVC Troubleshooting Guide, Engine does not Start, What To Check, Remedy

Page 20

Troubleshooting Guide

ENGINE DOES NOT START

What To Check

 

 

 

Possible Cause

 

NO

 

Faulty recoil starter.

 

 

Does the engine crank?

 

Fluid in the crankcase.

 

 

 

 

Internal damage.

 

 

 

 

 

Remedy

Consult with an authorized servicing dealer.

YES

Good compression?

NO

Loose spark plug.

Excess wear on cylinder, piston, rings.

Tighten and re-test.

Consult with an authorized servicing dealer.

YES

 

 

NO

 

Fuel incorrect, stale, or contaminated;

 

 

 

Does the tank contain

 

mixture incorrect.

fresh fuel of the proper

 

 

 

 

 

 

 

 

 

 

grade?

 

 

 

 

 

 

 

 

 

 

 

YES

 

 

 

 

 

 

 

 

NO

 

Check for clogged fuel filter and/

 

 

 

 

 

Is fuel visible and moving

 

in the return line when

 

 

 

 

or vent.

 

 

 

 

priming?

 

 

 

 

 

 

 

 

 

 

 

 

Refill with fresh, clean unleaded gasoline with a pump octane of 87 or higher mixed with a premium 2-cycle mixing oil or with an equivalent high quality 2-cycle mixing oil.

Replace fuel filter or vent as required. Restart.

YES

Is there spark at the spark plug wire terminal?

YES

Check the spark plug.

The ignition switch is in “O” (OFF) NO position.

Shorted ignition ground.

Faulty ignition unit.

If the plug is wet, excess fuel may be in the cylinder.

The plug is fouled or improperly gapped.

The plug is damaged internally or of the wrong size.

Move switch to “I” (ON) position and restart.

Consult with an authorized servicing dealer.

Crank the engine with the plug removed, reinstall the plug, and restart.

Clean the spark plug. Check the Specifications section for the correct plug and gap for your unit. Restart.

Replace the spark plug. Check the Specifications section for the correct plug and gap for your unit. Restart.

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents T3410/EVC Trimmer T3410X/EVC Trimmer Contents IntroductionSafety Safety LabelsWork Safely Stay AlertProperly Equipped Operator Be Aware of the Working EnvironmentProduct Description Outer Tube Gearcase Cutting Attachment Shield Trimmer HeadAssembly Prior to AssemblyEngine and shaft assembly Cutting attachment shield Handle and barrier bar X unitSub-Shield When trimmer head is in use Cutting Attachment Shield T, TX unitAdjust throttle lever free play Install trimmer headInstalling Brushcutter Blade Remove the hex wrenchMixing fuel Filling the fuel tankExamples of 501 mixing quantities Minimize the Risk of FireDepress and hold the throttle lock button When the Engine StartsStarting the Engine Adjusting Engine Idle Idle Speed AdjustmentStopping the Engine Checking Unit ConditionOperation Using a Blade Blade ThrustBrushcutter Handlebar Brushcutter harnessMaintenance Hour maintenance 10/15-Hour maintenanceRemove and clean or replace the spark plug Gearcase lubrication139/150-Hour Maintenance Valve AdjustmentMaintenance after first 139-hours Remove and replace the fuel filter ElementLong Term Storage 0XIÁHUDQGVSDUNDUUHVWHU DlqwhqdqfhMultiple-tooth Circular Blade Blade SharpeningShindaiwa Tornado Blade Troubleshooting Guide Engine does not StartWhat To Check RemedyLOW Power Possible CauseIs the engine overheating? Engine is knockingAdditional Problems What To Check Possible Cause RemedyEmission System Warranty Statement NOTAs RemarquesPodadora T3410 Podadora T3410X Introducción ContenidoDeclaraciones De Seguridad Etiquetas de seguridadSeguridad Trabaje con cuidadoMantengase Alerta Etiquetas de seguridadSP4 Seguridad continuaciónEl operario debidamente equipado Descripción del Producto VshflàfdflrqhvMango y barra protectora unidades TX EnsamblajeAntes de Ensamblar SP7 Protector Secundario cuando elProtector del accesorio de corte Ensamblaje continuacion Ajuste la holgura del aceleradorInstalación del cabezal de corte Retire la llave hexagonalInstalación de la cuchilla desmalezadora Mezcla de Combustible Llenando el Tanque de CombustibleEjemplos de cantidades de mezcla a proporción de Disminuya el riesgo de incendiosArranque del motor Al arrancar el motorDeslice el interruptor de ignición a la Posición O motor ApagadoOperación Correa de HombroCorte de Césped Máquinas Equipadas con Cabezal de Corte BordesOperación continuación Mantenimiento Mantenimiento continuación Mantenimiento cada 10 horasMantenimiento cada 50 horas Más frecuentemente en condiciones rigurosasMantenimiento Cada 139/150 Horas Ajuste de válvulasRetire y reemplace el elemento del filtro Un ajuste incorrecto de las válvuMantenimiento de la silenciador Almacenamiento de Largo PlazoRetire la malla y limpie con un cepillo de cerdas gruesas Repita los pasos 1 y 2 hasta que el motor ya no arranqueDisco Shindaiwa Tornado Discos de dientes múltiplesGuía Diagnóstico EL Motor no ArrancaQué revisar Posible causaBaja Potencia ¿Se sobrecalienta el motor?Limpiar, reparar o sustituir en caso necesario El motor golpeaGuía Diagnóstico continuación Esta garantía es administrada por Sus Derechos y Obligaciones de GarantíaCobertura de la Garantía del Fabricante Que Está Cubierto Por Esta GarantíaTualatin, Oregon 97062 USA 11, Ozuka-Nishi COUPE-BORDURE T3410/EVC T3410X/EVC Table des matières Mises en gardeSécurité Sécurité au travailDemeurer alerte Étiquettes de sécuritéSécurité suite Équipement complet de l’utilisateurNomenclature Caractéristiques techniquesAssemblage Avant l’assemblagePoignée y Barre de sécurité X appareil FR6Assemblage suite PÁHFWHXUPÁHFWHXULQIpULHXUlorsque la tête FR7Installer la tête de coupe Réglage du jeu du levier d’accélérationRetirer la clé hexagonale du boîtier ’engrenage et des supportsInstallation de la lame de débroussailleuse Mélange de carburant Remplissage du réservoir à carburantExemples de quantités de mélange de carburant à Réduire les risques d’incendieDémarrage du moteur Lorsque le moteur démarreDémarrage du moteur suite Arrêt du moteurRéglage du ralenti du moteur Contrôle de l’état de l’appareilFonctionnement Fonctionnement suite Entretien Entretien suite Entretien aux 10 heuresEntretien aux 10 à 15 heures Entretien aux 50 heuresRemplacement du filtre à carburant Entretien toutes les 50 heures suiteEntretien aux 139 heures Réglage du jeu des soupapesRemisage à long terme Entretien du silencieuxLame circulaire à plusieurs dents Affûtage de la lameLame Shindaiwa Tornado Solution Guide de dépannageLE Moteur NE Démarre PAS Points à contrôlerGuide de dépannage suite Puissance InsuffisanteLe moteur surchauffe-t-il ? Le moteur cognePoints à contrôler Cause probable Solution Autres ProblèmesLa présente garantie est administrée par Vos droits et obligations en vertu de la garantieCouverture de la garantie des fabricants Couverture de la garantie

T3410X/EVC, T3410/EVC, 89301 specifications

Shindaiwa is renowned for its durable and high-performing outdoor power equipment, and models like the Shindaiwa 89301, T3410/EVC, and T3410X/EVC highlight this reputation. These models are designed for both commercial and residential use, featuring advanced technologies that enhance performance and user experience.

The Shindaiwa 89301 is a versatile and powerful equipment that excels in various landscaping tasks. Its most notable feature is its robust engine, which provides exceptional power while maintaining fuel efficiency. This model incorporates Shindaiwa's advanced Clean Air Technology, which significantly reduces emissions, making it environmentally friendly and compliant with stringent regulations. The ergonomic design of the handle ensures comfort during prolonged use, reducing operator fatigue.

Moving on to the T3410/EVC, this model is primarily a brushcutter, known for its reliability and ease of use. It is equipped with a high-quality cutting system that delivers precise cuts and efficient grass clearing. The T3410/EVC features a powerful engine that provides strong torque at low RPMs, allowing for effective cutting through thick grass and weeds. One of the standout technologies in this unit is the E-Vac system, which enhances airflow in the cutting head for improved debris discharge. This ensures a clean and efficient cut, reducing the time spent on yard work.

Meanwhile, the T3410X/EVC model pushes the boundaries even further with additional capabilities. It features a more advanced ignition system that offers quicker starts and better overall performance in challenging conditions. This model also boasts a reinforced frame and components designed for demanding tasks, making it ideal for professionals who require reliability and performance. Just like the T3410/EVC, the T3410X/EVC is integrated with an advanced vibration dampening system, enhancing user comfort and control during operations.

Both models' user-friendly controls and lightweight design make them accessible for both seasoned professionals and casual users. Whether you are tackling a large commercial property or maintaining your backyard, Shindaiwa’s models 89301, T3410/EVC, and T3410X/EVC deliver exceptional performance, durability, and innovation, ensuring that your outdoor projects are completed efficiently and effectively. With a combination of power, technology, and ergonomic design, these models stand out in the competitive landscape of outdoor power equipment.
Top Page Image Contents