Shindaiwa T3410X/EVC, T3410/EVC, 89301 manual Operation

Page 13

Operation

Shoulder Strap

WARNING!

Always wear a shoulder strap when operating this unit with a blade. A shoulder strap is also recommened when using trimmer line.

1.Hook the strap hook to the hanger on the outer tube.

2.Wear the shoulder strap so that the hook stays at your right hand side.

 

 

 

IMPORTANT!

TX unit

 

 

Adjust the shoulder strap or harness so the

 

Harness

 

shoulder pad rests comfortably on the off-side

 

 

shoulder and the cutting path of the cutting

 

 

 

 

 

 

attachment is parallel to the ground. Make sure

 

 

 

all hooks and adjustment devices are secure.

 

 

 

 

3.Adjust the length of the shoulder strap so that you can hold and operate the machine comfortably.

Cutting grass with a trimmer head

Your Shindaiwa unit may be equipped with one of several Shindaiwa trimmer head mod- els, each with features for specific applica- tions and/or operational requirements.

NOTE:

For proper operation, always refer to the instructions accompanying the trimmer head being used.

Trimmer head styles:

Semi-automatic. Trimmer line is indexed when the operator taps the trimmer head on the ground during operation.

Manual. The operator indexes line manu- ally with the grass trimmer stopped.

Fixed. The operator must stop the unit and add new lengths of trimmer line manually.

Flail. This device, designed for clearing weeds and light brush, features three nylon blades attached to the head by pivots.

Edging

Tilt the handle about 100° to the left (from horizontal) and move forward, holding the trimmer or brushcutter vertically as shown.

NOTE:

Additional hardware may be required to mount the Fixed Line or the Flail type trimmer heads.

Engine Operating Speeds

Operate at full throttle while cutting grass.

CAUTION!

Operation at low rpm can lead to pre- mature clutch failure.

Trimming and Mowing Grass

Hold the grass trimmer so the trimmer head is angled slightly into the area to be cut. To ensure maximum trimmer-line service life, cut only with the tip of the trimmer line. Cut grass by swinging the unit's trimmer head from left to right. Keep the trimmer head horizontal.

Tilt the handle about

100° to the left

CAUTION!

ŶDo not push the rotating line into trees, wire fences or any material that could tangle or break line ends.

ŶOperation of trimmer without a cutting attachment shield and using exces- sive line length can lead to premature clutch failure.

ŶOperation at low rpm can lead to premature clutch failure.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents T3410/EVC Trimmer T3410X/EVC Trimmer Introduction ContentsSafety Labels SafetyWork Safely Stay AlertBe Aware of the Working Environment Properly Equipped OperatorOuter Tube Gearcase Cutting Attachment Shield Trimmer Head Product DescriptionPrior to Assembly AssemblyEngine and shaft assembly Cutting attachment shield Handle and barrier bar X unitCutting Attachment Shield T, TX unit Sub-Shield When trimmer head is in useInstall trimmer head Adjust throttle lever free playRemove the hex wrench Installing Brushcutter BladeFilling the fuel tank Mixing fuelExamples of 501 mixing quantities Minimize the Risk of FireStarting the Engine When the Engine StartsDepress and hold the throttle lock button Idle Speed Adjustment Adjusting Engine IdleStopping the Engine Checking Unit ConditionOperation Blade Thrust Using a BladeBrushcutter Handlebar Brushcutter harnessMaintenance 10/15-Hour maintenance Hour maintenanceRemove and clean or replace the spark plug Gearcase lubricationValve Adjustment 139/150-Hour MaintenanceMaintenance after first 139-hours Remove and replace the fuel filter Element0XIÁHUDQGVSDUNDUUHVWHU Dlqwhqdqfh Long Term StorageShindaiwa Tornado Blade Blade SharpeningMultiple-tooth Circular Blade Engine does not Start Troubleshooting GuideWhat To Check RemedyPossible Cause LOW PowerIs the engine overheating? Engine is knockingWhat To Check Possible Cause Remedy Additional ProblemsEmission System Warranty Statement Remarques NOTAsPodadora T3410 Podadora T3410X Contenido IntroducciónDeclaraciones De Seguridad Etiquetas de seguridadTrabaje con cuidado SeguridadMantengase Alerta Etiquetas de seguridadEl operario debidamente equipado Seguridad continuaciónSP4 Vshflàfdflrqhv Descripción del ProductoAntes de Ensamblar EnsamblajeMango y barra protectora unidades TX Protector del accesorio de corte Protector Secundario cuando elSP7 Ajuste la holgura del acelerador Ensamblaje continuacionInstalación del cabezal de corte Retire la llave hexagonalInstalación de la cuchilla desmalezadora Llenando el Tanque de Combustible Mezcla de CombustibleEjemplos de cantidades de mezcla a proporción de Disminuya el riesgo de incendiosAl arrancar el motor Arranque del motorPosición O motor Apagado Deslice el interruptor de ignición a laCorrea de Hombro OperaciónCorte de Césped Máquinas Equipadas con Cabezal de Corte BordesOperación continuación Mantenimiento Mantenimiento cada 10 horas Mantenimiento continuaciónMantenimiento cada 50 horas Más frecuentemente en condiciones rigurosasAjuste de válvulas Mantenimiento Cada 139/150 HorasRetire y reemplace el elemento del filtro Un ajuste incorrecto de las válvuAlmacenamiento de Largo Plazo Mantenimiento de la silenciadorRetire la malla y limpie con un cepillo de cerdas gruesas Repita los pasos 1 y 2 hasta que el motor ya no arranqueDiscos de dientes múltiples Disco Shindaiwa TornadoEL Motor no Arranca Guía DiagnósticoQué revisar Posible causa¿Se sobrecalienta el motor? Baja PotenciaLimpiar, reparar o sustituir en caso necesario El motor golpeaGuía Diagnóstico continuación Sus Derechos y Obligaciones de Garantía Esta garantía es administrada porCobertura de la Garantía del Fabricante Que Está Cubierto Por Esta GarantíaTualatin, Oregon 97062 USA 11, Ozuka-Nishi COUPE-BORDURE T3410/EVC T3410X/EVC Mises en garde Table des matièresSécurité au travail SécuritéDemeurer alerte Étiquettes de sécuritéÉquipement complet de l’utilisateur Sécurité suiteCaractéristiques techniques NomenclatureAvant l’assemblage AssemblagePoignée y Barre de sécurité X appareil FR6PÁHFWHXU Assemblage suitePÁHFWHXULQIpULHXUlorsque la tête FR7Réglage du jeu du levier d’accélération Installer la tête de coupeRetirer la clé hexagonale du boîtier ’engrenage et des supportsInstallation de la lame de débroussailleuse Remplissage du réservoir à carburant Mélange de carburantExemples de quantités de mélange de carburant à Réduire les risques d’incendieLorsque le moteur démarre Démarrage du moteurArrêt du moteur Démarrage du moteur suiteRéglage du ralenti du moteur Contrôle de l’état de l’appareilFonctionnement Fonctionnement suite Entretien Entretien aux 10 heures Entretien suiteEntretien aux 10 à 15 heures Entretien aux 50 heuresEntretien toutes les 50 heures suite Remplacement du filtre à carburantEntretien aux 139 heures Réglage du jeu des soupapesEntretien du silencieux Remisage à long termeLame Shindaiwa Tornado Affûtage de la lameLame circulaire à plusieurs dents Guide de dépannage SolutionLE Moteur NE Démarre PAS Points à contrôlerPuissance Insuffisante Guide de dépannage suiteLe moteur surchauffe-t-il ? Le moteur cogneAutres Problèmes Points à contrôler Cause probable SolutionVos droits et obligations en vertu de la garantie La présente garantie est administrée parCouverture de la garantie des fabricants Couverture de la garantie

T3410X/EVC, T3410/EVC, 89301 specifications

Shindaiwa is renowned for its durable and high-performing outdoor power equipment, and models like the Shindaiwa 89301, T3410/EVC, and T3410X/EVC highlight this reputation. These models are designed for both commercial and residential use, featuring advanced technologies that enhance performance and user experience.

The Shindaiwa 89301 is a versatile and powerful equipment that excels in various landscaping tasks. Its most notable feature is its robust engine, which provides exceptional power while maintaining fuel efficiency. This model incorporates Shindaiwa's advanced Clean Air Technology, which significantly reduces emissions, making it environmentally friendly and compliant with stringent regulations. The ergonomic design of the handle ensures comfort during prolonged use, reducing operator fatigue.

Moving on to the T3410/EVC, this model is primarily a brushcutter, known for its reliability and ease of use. It is equipped with a high-quality cutting system that delivers precise cuts and efficient grass clearing. The T3410/EVC features a powerful engine that provides strong torque at low RPMs, allowing for effective cutting through thick grass and weeds. One of the standout technologies in this unit is the E-Vac system, which enhances airflow in the cutting head for improved debris discharge. This ensures a clean and efficient cut, reducing the time spent on yard work.

Meanwhile, the T3410X/EVC model pushes the boundaries even further with additional capabilities. It features a more advanced ignition system that offers quicker starts and better overall performance in challenging conditions. This model also boasts a reinforced frame and components designed for demanding tasks, making it ideal for professionals who require reliability and performance. Just like the T3410/EVC, the T3410X/EVC is integrated with an advanced vibration dampening system, enhancing user comfort and control during operations.

Both models' user-friendly controls and lightweight design make them accessible for both seasoned professionals and casual users. Whether you are tackling a large commercial property or maintaining your backyard, Shindaiwa’s models 89301, T3410/EVC, and T3410X/EVC deliver exceptional performance, durability, and innovation, ensuring that your outdoor projects are completed efficiently and effectively. With a combination of power, technology, and ergonomic design, these models stand out in the competitive landscape of outdoor power equipment.
Top Page Image Contents