Shindaiwa 81646 manual Additional Problems

Page 18

Troubleshooting Guide (continued)

ADDITIONAL PROBLEMS

Symptom

Possible Cause

Remedy

Poor acceleration.

Engine stops abruptly.

Engine difficult to shut off.

Clogged air filter.

Clogged fuel filter.

Lean fuel/air mixture.

Idle speed set too low.

Switch turned off.

Fuel tank empty.

Clogged fuel filter.

Water in the fuel.

Shorted spark plug or loose terminal.

Ignition failure.

Piston seizure.

Ground (stop) wire is disconnected, or switch is defective.

Clean or replace the air filter.

Replace the fuel filter.

Consult with an authorized servicing dealer. Adjust: 2,750 (±250) rpm (min-1)

Reset the switch and re-start.

Refuel. See page 9.

Replace filter.

Drain; replace with clean fuel. See page 9.

Clean or replace spark plug with a Champion CJ8 or equivalent type spark plug of the correct heat range.

Replace the ignition unit.

Consult with an authorized servicing dealer.

Test and replace as required.

Overheating due to incorrect spark plug.

Replace spark plug with a Champion CJ8 or

 

equivalent spark plug of the correct heat

 

range.

Cutting attachment rotates at engine idle.

Excessive vibration.

Cutting attachment will not rotate.

Overheated engine.

Engine idle too high.

Broken clutch spring or worn clutch spring boss.

Loose attachment holder.

Warped or damaged cutting attachment.

Loose gearcase.

Bent main shaft/worn or damaged bushings.

Shaft not installed in powerhead or gearcase.

Broken shaft.

Damaged gearcase.

Idle engine until cool.

Set idle: 2,750 (±250) rpm (min-1)

Replace spring/shoes as required, check idle speed.

Inspect and re-tighten holders securely.

Inspect and replace attachment as required.

Tighten gearcase securely.

Inspect and replace as necessary.

Inspect and reinstall as required.

Consult with an authorized servicing dealer. Consult with an authorized servicing dealer.

18

Image 18
Contents T261 Trimmer T261X Trimmer Contents IntroductionStay Alert General Safety Instructions The Properly Equipped OperatorWork Safely Minimize the Risk FireSafety Labels Be Aware of the Working EnvironmentSpecifications Product DescriptionPrior to Assembly Assembly and AdjustmentsAdjust Throttle Lever Free Play HandleInstall the Trimmer Head Assembly Cutting Attachment ShieldAssembly Trimmer Head Install the Cutting Attachment ShieldAssembly Blade T261X Never operate the T261X without the safety clip in placeMount the Cutting Blade Starting the Engine Mixing FuelFilling the Fuel Tank Examples of 501 mixing quantitiesIdle Speed Adjustment Adjusting Engine IdleWhen the Engine Starts Starting the EngineChecking Unit Condition Shoulder StrapCutting Grass-Units Equipped with a Trimmer Head Using a Blade T261X General Maintenance Daily MaintenanceHour Maintenance 10/15-Hour Maintenance Hour MaintenanceBlade Sharpening Hour MaintenaceLong Term Storage Shindaiwa Tornado BladeTroubleshooting Guide Engine does not StartLOW Power Output Additional Problems Exceptions Purchased Repair Parts and Accessories 99922201033 Page Page Servicing Information Parts/Serial NumberManual Del Propietario/Operador Shindaiwa ¡ADvERTENCIAIntroducción Declationes De Seguridad Contenido¡ADvERTENCIA El Operario Debidamente Equipado Trabaje con cuidadoMantengase Alerta Esté Alerta del Area de Trabajo Etiquetas de SeguridadDescripción del Producto EspecificacionesDas a ninguna de éstas máquinas ni a sus componentes Ajuste la holgura del acelerador Ensamblaje y AjustesMango Antes de EnsamblarEnsamblaje Cabezal de Corte Para cambiar la posición de la cuchilla de corteInstalación del Cabezal de Corte Ensamblaje Disco/Cuchilla T261X Monte la Cuchilla de CorteNunca opere la T261 sin el retén de seguridad instalado Arranque del Motor Mezcla de CombustibleLlenando el Tanque de Combustible Disminuya el riesgo de incendiosCuando arranca el motor Parada del MotorAjuste de Marcha Mínima del Motor Ajuste de Marcha MínimaVerifique la Condición de la Unidad Correa de ArnésCorte de Césped Máquinas Equipadas con Cabezal de Corte Usando un disco T261X Mantenimiento General Mantenimiento DiarioMantenimiento Cada 10-Horas Mantenimiento cada 10/15-Horas Mantenimiento Cada 50-HorasAfilado de Discos Mantenimiento Cada 135-HorasAlmacenamiento de Largo Plazo Disco Shindaiwa TornadoGuía Diagnóstico El Motor No ArrancaGuía Diagnóstico continuación Baja Potencia’ntoma Posible Causa Remedio Responsabilidad DE Echo Piezas DE Reparación COMPRADAS, Bloques Cortos Y Accesorios 01/2010 Cobertura DE Garantía DEL FabricanteNotas Notas Información de servicio Piezas/número de serie