Teac SR-L35CD owner manual For U.S.A, English

Page 3
For U.S.A.

WARNING : TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

<DO NOT REMOVE THE EXTERNAL CASES OR CABINETS TO EXPOSE THE ELECTRONICS. NO USER SERVICEABLE PARTS ARE WITHIN!

<IF YOU ARE EXPERIENCING PROBLEMS WITH THIS PRODUCT, CONTACT TEAC FOR A SERVICE REFERRAL. DO NOT USE THE PRODUCT UNTIL IT HAS BEEN REPAIRED.

<USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

For U.S.A.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the equipment and/or the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

CAUTION

Changes or modifications to this equipments not expressly approved by TEAC CORPORATION for compliance will void the user’s warranty.

This product has been designed and manufactured according to FDA regulations “title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968“, and is classified as class 1 laser product. There is not hazardous invisible laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings.

The label required in this regulation is shown ①.

① For U.S.A.

(rear panel of the unit)

Optical pickup :

 

Type

: CMS-M95BG6

Manufacturer

: SAMSUNG

Laser output

: 0.5mW on the objective lens

Wavelength

: 760 - 800 nm

 

 

ENGLISH

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents ENGLISH FRANÇAIS ? SR-L35CD Receiver IMPORTANT SAFETY INSTRUCTIONS ENGLISH For U.S.AWHEN MOVING THIS UNIT ContentsBefore Use MaintenanceCompact Disc Precautions concerning batteries Remote Control UnitBattery Installation Battery ReplacementUse of the folding supports Wall MountingFRONT Names of Each ControlJ AK U T R SA STANDBY/ON switch Playing a CD AB D Search for a part of a track F C D A To stop playbackB To suspend playback temporarily pause mode C To skip to the next or a previous trackProgrammed Playback 1 Press the MEMORY/CLOCK ADJ button in the stop mode2 Within 10 seconds, press the SKIP/SEARCH button to select a track To add a track to the end of the program To cancel the program playback modeMEMORY/CLOCK ADJ To check the programmed orderRepeat All the Tracks Repeat PlaybackShuffle Playback Repeat one trackIf the reception is poor Listening to the RadioPress the BAND button to select FM or AM How to Preset StationsHow to select Preset Stations In each band, up to 10 stations can be stored in presetSleep Timer How to connect external sourcesListening to the External Sources Clock Adjustment Setting the timer TimerTo cancel the timer mode Activating the timerGeneral TroubleshootingSpecifications Remote Control UnitNE DEPLACEZ PAS CET APPAREIL PENDANT L’ECOUTE D’UN DISQUE SommaireAvant utilisation CONSIGNES DE DEPLACEMENT DE CET APPAREILFRANÇAIS Disques compactsPrécautions à observer concernant les piles Boîtier de télécommandeRemplacement des piles Mise en place des pilesEmploi des supports pliants Accrochage au murDEVANT NomenclatureUtilisez cette touche pour changer le mode d’affichage Lecture du CD Appuyer sur la touche STOP H pour arrêter la lecture Lecture programmée En mode arrêt, appuyer la touche MEMORY/CLOCK ADJ répététivement jusqu’ à temps que le numéro de piste à changer est affiché Répétition de toute les pistes Lecture répétitiveLecture aléatoire Répétition d’une pisteSi la récepion est mauvaise Ecoute radioSélection des stations préréglées Comment préréglé une stationMinuterie sommeil Ecoute à partir d’une source externePour connecter des appareils externes Réglage de l’horloge Réglage de la minuterie MinuteriePour annulement du mode minuterie Activation de la minuterieGénéralité TélécommandeGuide de dépannage SpécificationsModel number Serial number0604.MA-0894A
Top Page Image Contents