Multiquip SG1400C3-55748 manual Before Starting, Engine’s exhaust contains harmful emissions

startup

FUEL VALVES IN PRIME MODE

Figure 21. Fuel Valves (Prime Mode) ON (UP)

Figure 22. Fuel Priming Switch (ON)

4. After priming is complete, release the fuel priming switch. Place the fuel valves in the run mode (Figure

23). FUEL VALVES IN

RUN MODE

Figure 23. Fuel Valves (Run Mode)

5. Verify that all three circuit breakers (Figure 24)are in the ON position prior to starting the engine.

Before Starting

CAUTION

The engine’s exhaust contains harmful emissions.

ALWAYS have adequate ventilation when operating.

1.Place the Control Power switch (Figure 18) on the digital control panel in the up position (ON).

ON (UP)

Figure 18. Control Power Switch (ON)

2.Place the voltage selector switch (Figure 19) in the desired voltage setting position. The corresponding Voltage Status LED on the control panel will light to indicate the selected voltage (Figure 20).

120/208 3

277/480 3

120/240 1

Figure 19. Voltage Selector Switch

120/208 3Ø Position

LIGHTS IF

SELECTED

Figure 20. Voltage Status LEDs

3.If it is necessary to prime engine before starting (such as after changing fuel filter or running out of fuel), place the fuel valves in the prime position (Figure 21). Place the fuel priming switch (Figure 22) in the up position.

VERIFY CIRCUIT	ON
BREAKERS ARE ON
Electronic Trip Unit			Test
Push to Trip	A — 500	E — 1250
450 AMP	B — 600	F — 1500
	C — 800	G — 2000
LONG — INST.	D — 1000	H — 2500	Status

Figure 24. Circuit Breakers (ON)

page 34 — SG1400C3 Studio Generator • operation and parts manual — rev. #1 (02/15/12)