Land Pride 357-044M manual Safety at All Times

Page 3

Land Pride

Table of Contents

Important Safety Information

These are common practices that may or may not be applicable to the products described in this manual.

Safety at All Times

Thoroughly read and understand the instructions given in this manual before operation. Refer to the “Safety Label” section, read all instructions noted on them.

Do not allow anyone to operate this equipment who has not fully read and comprehended this manual and who has not been properly trained in the safe operation of the equipment.

Look For The Safety Alert Symbol

The SAFETY ALERT SYMBOL indicates there is a

!extra safety precaution must be taken. When you see this symbol, be alert and carefully read the message that follows it. In addition to design and configuration of equipment, hazard control and accident prevention are dependent upon the awareness, concern, prudence and proper training

of personnel involved in the operation, transport, maintenance and storage of equipment.potential hazard to personal safety involved and

Operator should be familiar with

all functions of the unit.

Operate implement from the

driver’s seat only.

Do not leave equipment

unattended with engine running.

Dismounting from a moving

mower could cause serious injury

or death.

Do not stand between the mower

and implement during hitching.

Keep hands, feet, and clothing

away from power-driven parts.

Wear snug fitting clothing to avoid

entanglement with moving parts.

Watch out for wires, trees, etc.,

when raising implement. Make

sure all persons are clear of

working area.

Turning mower too tight may

cause implement to ride up on

Be Aware of

Signal Words

A Signal word designates a degree or level of hazard seriousness. The signal words are:

!DANGER

Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. This signal word is limited to the most extreme situations, typically for machine components that, for functional purposes, cannot be guarded.

!WARNING

Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury, and includes hazards that are exposed when guards are removed. It may also be used to alert against unsafe practices.

!CAUTION

Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. It may also be used to alert against unsafe practices.

wheels. This could result in injury

or equipment damage.

For Your Protection

Thoroughly read and understand the “Safety Label” section, read all instructions noted on them.

Shutdown and Storage

Lower machine to ground, put mower in park, turn off engine, and remove the key.

Detach and store implements in a area where children normally do not play. Secure implement by using blocks and supports.

OFF

2/27/07

Z44 & Z52 (S/N 472620 -526170) Zero Turning Radius Mowers Riding Mowers Accu-Z Razor® 357-044M

1

Image 3
Contents Riding Mowers Accu-Z Razor Table of Contents Safety at All Times Practice Safe Maintenance Keep Riders Off MachineryAvoid High Pressure Fluids Hazard Wear Protective Equipment Prepare for Emergencies838-815C 838-303C838-307C 838-308C 838-833C 838-310C 818-543C Using This Manual ApplicationOwner Assistance Uncrating Instructions Control Lever AssemblySeat Assembly Hitch Plate AssemblyElectrical Cable Connection Engine PreparationsRemove Mower From Crate Floor Mower Features Razor FeaturesMuffler Shield Is Located Under Engine Land PrideTable of Contents Park Lever Blade Engagement SwitchLeft/Right Fuel Tank Valve Control LeversDeck Lift Pedal Safety Start Interlock SystemDeck Height Deck Lift Locking Pin Pedal Indicator Engine StartingSteering Driving the MowerTo Decrease Speed or Stop To Start and Increase SpeedBypass Valve Rods Moving Mower with Stalled EngineFront of Mower Faces This Direction SteeringSafe Operating Instructions Discharge Chute Blade Blade Engagement SwitchMower Deck Operation General Operating InformationFT lbs Torque ValuesSteering Linkage Torque ValuesSteering Dampener Control Lever Neutral AdjustmentReach Adjustment Seat AdjustmentUpper Control Lever Adjustments Height AdjustmentDeck Leveling & Height Adjustment Hydro-Drive Belt AdjustmentEngine RPM Setting Deck Drive Belt AdjustmentStop Handle Height Adjusting StopAdjuster Bolt Jam Nut Hardware Refer to -9& Figure Refer to FigureDeck Lift Rod Adjustment Left Front Side Shown Refer to -10onLift Refer to -12on Deck Cutting Height AdjustmentAnti-Scalp Rollers Pivot Front WheelsDeck Bottom View Drive motors removed for clarity Maintenance LocationsService at Intervals Indicated Every Refer to Hours Maintenance ScheduleMaintenance Electrical System BatteryWiring Harness Fusses TiresRefer to Refer to Figure Access to IZT Units Integrated Zero-Turn TransaxleHydraulic System Hydraulic oil and FilterFuel System Oil Check, Honda Engine Fuel FilterDraining The Fuel Tank Engine Oil and Oil FilterEngine Air Filter General Engine MaintenanceBelt Replacement Deck Belt Replacement InstructionsRefer to -11on Mower Blade MaintenanceDrive Belt Replacement Instructions Blade InspectionRefer to -15and Figure Blade SharpeningStorage Preparation of Engine for StorageNew Season Preparation Left Blade Spindle Lubrication PointsHours Center Blade SpindleDeck Lift Pivot Points 100/M HoursGauge Wheel Bearing Zerk Front Axle Center PivotEngine Type Z44 & Z52 Accu-Z Razor Engine SpecificationsZ44 & Z52 Accu-Z Razor General Specifications Specifications to continue on nextIndicators Brake ServiceSafety Features Deck Housing DepthPark lever to OFF Hydro-Gear IZT Features BenefitsZ44 & Z52 Accu-Z Razor For the operator Steering levers designed forOverheating Engine cranks but does not startEngine Either directionLevers are in neutral Mower creeps when steering controlOne direction only Hydraulic system operates hotIn-tpi Torque Values ChartTire Inflation Chart Additional Torque ValuesBelts, blades, and tires are considered wear items WarrantyCorporate Office P.O. Box Salina, Kansas 67402-5060 USA

357-044M specifications

The Land Pride 357-044M is a cutting-edge implement designed to meet the needs of professionals and enthusiasts in the agricultural sector. Known for its robust construction and innovative features, this attachment is ideal for enhancing productivity in various land management tasks.

One of the main features of the Land Pride 357-044M is its heavy-duty design, which is specifically built to withstand the rigors of daily use in demanding environments. The durable frame ensures longevity, allowing operators to tackle tough soil conditions without worrying about equipment failure. Additionally, the implement is equipped with high-quality materials that resist wear and tear, providing peace of mind for long-term reliability.

The 357-044M shines in its versatility. It can be used for a variety of applications, such as leveling ground, grading, and even snow removal in winter months. With adjustable features, operators can easily modify the attachment to suit specific job requirements, making it a multi-functional tool for land preparation.

Equipped with advanced technologies, the Land Pride 357-044M includes precision-engineered components that optimize performance. The attachment’s unique blade design enhances soil mixing and aeration, leading to improved crop yields. Furthermore, the implement's innovative hydraulic system allows for smooth and efficient operation, ensuring that the tool can be adapted to different tasks with minimal effort.

Operator comfort and efficiency are also key characteristics of the 357-044M. The implement features user-friendly controls, making it easy to operate even for those who may be unfamiliar with such equipment. The design takes into account ease of attachment and detachment from various tractors, promoting a seamless workflow on the job site.

In summary, the Land Pride 357-044M is a versatile and dependable implement that combines a robust design, innovative technologies, and operator-friendly features. Its ability to perform multiple tasks makes it an essential addition to any agricultural operation. With a focus on durability and efficiency, this attachment is sure to stand the test of time while delivering the performance that land management professionals demand.