Land Pride 357-044M manual Tires, Electrical System, Battery, Amp Fuse, Wiring Harness Fusses

Page 31

Land PrideTable of Contents

Section 4: Maintenance & Lubrication

Tires

Use only tires recommended by Land Pride. Solid fill tires are not to be used on the Razor mower.

It is important for your safety and the safety of others that the tires have correct air pressure. Check air pressure in all four tires before each use. Visually inspect tires for loss of air throughout each day of operation. See Tire Inflation Chart below for correct tire pressure.

Tire Inflation Chart

Tire

Inflation PSI

 

 

Drive Wheels

8-12

 

 

Gauge Wheels

8-12

 

 

Electrical System

Refer to Figure 4-2:

The battery is located under the seat. The electrical system is a 12 volt, negative ground. Recommended battery size is a garden mower BCI group U1R with 225 or better cranking AMP rating. A maintenance-free battery is recommended. Otherwise, follow battery manufacturer’s maintenance, safety, storing and charging specifications.

Battery

23629

Battery

Figure 4-2

!WARNING

Acid can cause serious injury to skin and eyes. Avoid skin contact with battery acid and always wear eye protection when checking the battery. Flush area with clean water and call a physician immediately. Acid will also damage clothing.

!WARNING

Do not allow an open flame near the battery when charging. Hydrogen gas forms inside the battery. This gas is both toxic and flammable and may cause an explosion if exposed to a flame.

!WARNING

Incorrect battery cable connections can damage mower’s electrical system and cause battery cables to spark. Sparks around a battery can result in a battery gas explosion and personal injury.

Always disconnect negative (black) battery cable before disconnecting positive (red) cable.

Always reconnect positive (red) battery cable to the positive (+) post before reconnecting negative (black) cable to the negative (-)post.

!WARNING

Keep battery terminals from touching any metal mower parts when removing or installing the battery. Do not allow metal tools to short between the battery terminals and metal mower parts. Shorts caused by battery terminals or metal tools touching metal mower components can cause sparks. Sparks can cause a battery gas explosion which will result in personal injury.

!WARNING

Do not overfill battery. Electrolyte may overflow and damage paint, wiring or structure. When cleaning the battery, use soap and water. Be careful not to get soap and water into the battery. Use soda mixed in water to clean corrosion off the terminals.

Common circuit problems are usually caused by electrical shorts, corroded or dirty terminals, loose connections, defective wire insulation or broken wires. Switches, solenoids and ignition components may also fail, causing a shorted or open circuit.

Refer to Figure 4-3:

The electrical system is protected by fuses located along the wire harness beneath the seat next to the engine. The fuses are:

Main - 20 Amp, blade type

Clutch - 10 Amp, blade type

20Amp Fuse

10Amp Fuse

23808

Wiring Harness Fusses

Figure 4-3

2/27/07

Z44 & Z52 (S/N 472620 -526170) Zero Turning Radius Mowers Riding Mowers Accu-Z Razor® 357-044M

29

Image 31
Contents Riding Mowers Accu-Z Razor Table of Contents Safety at All Times Keep Riders Off Machinery Practice Safe MaintenanceAvoid High Pressure Fluids Hazard Wear Protective Equipment Prepare for Emergencies838-815C 838-303C838-307C 838-308C 838-833C 838-310C 818-543C Application Using This ManualOwner Assistance Uncrating Instructions Control Lever AssemblySeat Assembly Hitch Plate AssemblyEngine Preparations Electrical Cable ConnectionRemove Mower From Crate Floor Razor Features Mower FeaturesMuffler Shield Is Located Under Engine Land PrideTable of Contents Park Lever Blade Engagement SwitchLeft/Right Fuel Tank Valve Control LeversDeck Lift Pedal Safety Start Interlock SystemDeck Height Deck Lift Locking Pin Pedal Indicator Engine StartingSteering Driving the MowerTo Decrease Speed or Stop To Start and Increase SpeedBypass Valve Rods Moving Mower with Stalled EngineFront of Mower Faces This Direction SteeringSafe Operating Instructions Discharge Chute Blade Blade Engagement SwitchMower Deck Operation General Operating InformationFT lbs Torque ValuesSteering Linkage Torque ValuesSteering Dampener Control Lever Neutral AdjustmentReach Adjustment Seat AdjustmentUpper Control Lever Adjustments Height AdjustmentDeck Leveling & Height Adjustment Hydro-Drive Belt AdjustmentEngine RPM Setting Deck Drive Belt AdjustmentStop Handle Height Adjusting StopAdjuster Bolt Jam Nut Hardware Refer to -9& Figure Refer to FigureRefer to -10on Deck Lift Rod Adjustment Left Front Side ShownLift Refer to -12on Deck Cutting Height AdjustmentAnti-Scalp Rollers Pivot Front WheelsDeck Bottom View Drive motors removed for clarity Maintenance LocationsService at Intervals Indicated Every Refer to Hours Maintenance ScheduleMaintenance Electrical System BatteryWiring Harness Fusses TiresRefer to Refer to Figure Access to IZT Units Integrated Zero-Turn TransaxleHydraulic System Hydraulic oil and FilterFuel System Oil Check, Honda Engine Fuel FilterDraining The Fuel Tank Engine Oil and Oil FilterEngine Air Filter General Engine MaintenanceBelt Replacement Deck Belt Replacement InstructionsRefer to -11on Mower Blade MaintenanceDrive Belt Replacement Instructions Blade InspectionRefer to -15and Figure Blade SharpeningPreparation of Engine for Storage StorageNew Season Preparation Left Blade Spindle Lubrication PointsHours Center Blade SpindleDeck Lift Pivot Points 100/M HoursGauge Wheel Bearing Zerk Front Axle Center PivotEngine Type Z44 & Z52 Accu-Z Razor Engine SpecificationsZ44 & Z52 Accu-Z Razor General Specifications Specifications to continue on nextIndicators Brake ServiceSafety Features Deck Housing DepthPark lever to OFF Hydro-Gear IZT Features BenefitsZ44 & Z52 Accu-Z Razor For the operator Steering levers designed forOverheating Engine cranks but does not startEngine Either directionLevers are in neutral Mower creeps when steering controlOne direction only Hydraulic system operates hotIn-tpi Torque Values ChartTire Inflation Chart Additional Torque ValuesBelts, blades, and tires are considered wear items WarrantyCorporate Office P.O. Box Salina, Kansas 67402-5060 USA

357-044M specifications

The Land Pride 357-044M is a cutting-edge implement designed to meet the needs of professionals and enthusiasts in the agricultural sector. Known for its robust construction and innovative features, this attachment is ideal for enhancing productivity in various land management tasks.

One of the main features of the Land Pride 357-044M is its heavy-duty design, which is specifically built to withstand the rigors of daily use in demanding environments. The durable frame ensures longevity, allowing operators to tackle tough soil conditions without worrying about equipment failure. Additionally, the implement is equipped with high-quality materials that resist wear and tear, providing peace of mind for long-term reliability.

The 357-044M shines in its versatility. It can be used for a variety of applications, such as leveling ground, grading, and even snow removal in winter months. With adjustable features, operators can easily modify the attachment to suit specific job requirements, making it a multi-functional tool for land preparation.

Equipped with advanced technologies, the Land Pride 357-044M includes precision-engineered components that optimize performance. The attachment’s unique blade design enhances soil mixing and aeration, leading to improved crop yields. Furthermore, the implement's innovative hydraulic system allows for smooth and efficient operation, ensuring that the tool can be adapted to different tasks with minimal effort.

Operator comfort and efficiency are also key characteristics of the 357-044M. The implement features user-friendly controls, making it easy to operate even for those who may be unfamiliar with such equipment. The design takes into account ease of attachment and detachment from various tractors, promoting a seamless workflow on the job site.

In summary, the Land Pride 357-044M is a versatile and dependable implement that combines a robust design, innovative technologies, and operator-friendly features. Its ability to perform multiple tasks makes it an essential addition to any agricultural operation. With a focus on durability and efficiency, this attachment is sure to stand the test of time while delivering the performance that land management professionals demand.