Generac Power Systems 5254, 5252, 5251, 5255, 5253 owner manual Listed

Page 1

C US

LISTED

Installation and Owner’s Manual

7, 10, 13 and 16kW Air-cooled, Automatic Standby Generators

Models: 005251 (6 kW NG, 7 kW LP) 005252 (9 kW NG, 10 kW LP)

005253 (13 kW NG, 13 kW LP) 005254, 005255 (15 kW NG, 16 kW LP)

GENERAC R

POWER SYSTEMS, INC.

R

	Not intended for use as Primary Power in place of utility or in	
	life-support applications.

DANGER

DEADLY EXHAUST FUMES. OUTDOOR INSTALLATION ONLY!

Image 1

Contents Listed Authorized Dealer Location IntroductionMaintenance Post Installation Start-up AdjustmentsTroubleshooting Introduction Inside Front Cover Warning  ‹ Standards Index  Electrical Hazards Protection Systems UNPACKING/INSPECTIONBreaker for Bedrooms 7kW, Single Cylinder GH-410 Engine Generator‹ 1.5.1 Generator Specifications‹ 1.5.2 Engine Fuel Requirements Recommendations System SET LEDFuel Consumption ‹ 1.8.1 BTU Flow Requirements Natural GAS‹ 1.9.1 7 KW, 410CC Engine Reconfiguring the Fuel System‹ 1.9.2 10, 13 and 16KW, V-TWIN Engines ‹ 1.10.1 Generator LocationBattery Installation Battery Requirements‹ 1.10.2 Transfer Switch 10.2.1 7, 10, 13, and 16 kW Units if equipped10 Battery Cable Connections BatteryBefore Initial START-UP Check Transfer Switch OperationElectrical Checks Checking Automatic Operation Generator Tests Under Load7KW Natural GAS only ‹ 2.7.1 7 KW Units Engine Governor Adjustment‹ 3.1.3 Manual Position ‹ 3.1.1 Auto PositionSequence of Automatic Operation Automatic Transfer OperationManual Transfer Operation ‹ 3.1.4 Choke Operation‹ 3.4.2 Transfer Back to Utility Power Source Setting the Exercise Timer‹ 3.6.2 High Temperature Switch ‹ 3.6.1 LOW OIL Pressure Switch‹ 3.6.3 Overcrank Approximate Crank Cycle TimesChecking the Engine OIL Level ‹ 3.6.6 LOW BatteryFuses ‹ 3.6.5 RPM Sensor Failure‹ 4.3.1 OIL Change Intervals Changing the Engine OIL‹ 4.3.2 Engine OIL Recommendations ‹ 4.4.1 7, 13, and 16KW Generators Spark Plugs‹ 4.4.2 10KW Generators Valve Clearance Battery Maintenance11 Cooling Vent Locations Cooling System‹ 4.11.2 Return to Service OUT of Service Procedure‹ 4.11.1 Removal from Service Corrosion ProtectionBe performed by the nearest Authorized Dealer Service ScheduleProblem Cause Correction Troubleshooting GuideAir-cooled Generators Air-cooled Generators Air-cooled Generators Mounting Dimensions Electrical Data Engine Wiring Customer Connection Battery Charger Engine Alternator Engine Wiring Stator Electronic Voltage Regulator Manual Auto Scsm Neutral Electrical Data Electrical Data Sheet Metal PAINT/MATERIAL Code Legend Part NO. QTY. Description Air-cooled Generators Control Panel Drawing No F9695-C QTY Description Exploded Views and Parts Lists BOX Load Center Exploded Views and Parts Lists Description QTY Exploded Views and Parts Lists Washer Flat M8 5/16 Exploded Views and Parts Lists Crankcase Exploded Views and Parts Lists Intake Adapter Exploded Views and Parts Lists PIN, Piston D20 Exploded Views and Parts Lists SCREW, Taptite M6-1.0X8 Yellow Chrome Air-cooled Generators 7kW, GN-410 Engine Drawing No F9422-B ADAPTOR, Engine Exploded Views and Parts Lists ADATOR, Engine 7KW CASTING, Twin Regulator Housing 7KW Exploded Views and Parts Lists Brkt Regulator Mounting MANUFACTURER’S Emission Control System Warranty Coverage Your Warranty Rights and ObligationsPURCHASER’S/OWNER’S Warranty Responsibilities Emission Related Parts Include the Following Emission Control System WarrantyGenerac Power Systems Standard Limited Warranty for