Black & Decker LGC120B Leaving the battery in the charger, Important Charging Notes

Page 7

3. The green LED will flash

A

indicating that the battery is being

charged.

 

4. The completion of charge

 

is indicated by the green LED

 

remaining on continuously. The

 

pack is fully charged and may

 

be used at this time or left on the

 

charger.

 

Recharge discharged batteries

 

as soon as possible after use

 

or battery life may be greatly

 

diminished. It is recommended

 

that the batteries be recharged after each use.

Leaving the battery in the charger

The charger and battery pack can be left connected with the green LED glowing indefinitely. The charger will keep the battery pack fresh and fully charged.

Important Charging Notes

1. Longest life and best performance can be obtained if the battery pack is charged when the air temperature is between 60°F and 80°F (16°- 27°C). DO NOT charge the battery pack in an air temperature below +40°F (+4.5°C), or above +105°F (+40.5°C). This is important and will prevent serious damage to the battery pack.

2. The charger and battery pack may become warm to touch while charging. This is a normal condition, and does not indicate a problem. To facilitate the cooling of the battery pack after use, avoid placing the charger or battery pack in a warm environment such as in a metal shed, or an uninsulated trailer.

3.If the battery pack does not charge properly:

a.Check current at receptacle by plugging in a lamp or other appliance

b.Check to see if receptacle is connected to a light switch which turns power off when you turn out the lights.

c.Move charger and battery pack to a location where the surrounding air temperature is approximately 60°F and 80°F (16°- 27°C)

d.If charging problems persist, take the tool, battery pack and charger to your local service center.

4.The battery pack should be recharged when it fails to produce sufficient power on jobs which were easily done previously.

DO NOT CONTINUE to use under these conditions. Follow the charging procedure. You may also charge a partially used pack whenever you desire with no adverse affect on the battery pack.

5.Foreign materials of a conductive nature such as, but not limited to, steel wool, aluminum foil, or any buildup of metallic particles should be kept away from charger cavities. Always unplug the charger from the power supply when there is no battery pack in the cavity. Unplug charger before attempting to clean.

6.Do not freeze or immerse charger in water or any other liquid.

WARNING: Shock hazard. Do not allow any liquid to get inside charger. Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack breaks or cracks, return to a service center for recycling.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents VEA EL ESPA-OL EN LA Contraportada Save this manual for future referencePour LE FRANÇAIS, Voir LA Couverture ARRIÈre General Safety for all tools Table of ContentsAdditional Warnings for Cultivators Battery Related WarningsKeep Shroud in Place and in Working Order Components Important safety instructions For battery chargersAmpere Rating Charging Procedure Important safety instructions For battery PacksImportant Charging Notes Leaving the battery in the chargerPole Extension Fig. D Installing / Removing Battery PackAssembly Auxiliary Handle Assembly Fig. CFirmly in Place Shroud Assembly Fig. ETine Assembly Fig. F Complete stop, and remove battery Operation Fig. G, HPreventing Corrosion AccessoriesMaintenance StorageService Information TroubleshootingFull Two-Year Home Use Warranty Mode d’emploi Table DES Matières Lignes directrices en matière de Sécurité définitionsÉviter LES Conditions Environnementales Sécurité Générale Pour Tous LES OutilsLire Toutes CES Directives Avertissements Supplémentaires Pour LES CultivateursUtiliser seulement le chargeur fourni Avertissements Relatifs AUX Piles ET BLOCS-PILESComposantes Intensité a Directives de sÉcuritÉ importantes pour Les blocs-piles Conserver CES DirectivesRemarques importantes pour le chargement Procédure de chargeFigure B Insertion et retrait du bloc-piles de ’outilRallonge fig. D Installation du flasque fig. EAssemblage Assemblage de la poignée auxiliaire fig. CMise EN Garde NE PAS Suspendre L’APPAREIL PAR LA Détente Fonctionnement fig. G,HEntretien AccessoiresSection de dépannage Information sur les réparations Manual DE Instrucciones Pautas DE SEGURIDAD/DEFINICIONES ÍndiceLEA Todas LAS Instrucciones Seguridad general para todas las HerramientaAdvertencias Adicionales Para Cultivadores Advertencias Sobre LA Batería Componentes Para Cargadores DE BateríasVolts Lea todas las instrucciones Notas importantes sobre la carga Procedimiento de cargaPara extraer el paquete Para instalar el paqueteMontaje de la cubierta Fig. E EnsamblajeMontaje del mango auxiliar Figura C Extensión de los postes Fig. DAlmacenamiento Operación Fig. G,HAdvertencia Asegúrese de que las demás personas y Mascotas estén a no menos de M 20 pies de distanciaMantenimiento AccesoriosEl sello Rbrc Garantía completa de dos años para uso En el hogar SecciÓn de detecciÓn de problemasProblema Causa posible Solución posible Información de mantenimientoPage Page Solamente Para Propositos DE Mexico
Related manuals
Manual 40 pages 22.94 Kb

LGC120B, LGC120 specifications

The Black & Decker LGC120 and LGC120B are renowned tools designed to simplify lawn care and deliver efficient performance for homeowners and garden enthusiasts. These cordless lithium-ion powered string trimmers combine power, portability, and user-friendly features, making them an excellent choice for tackling various landscaping tasks.

One of the standout features of both models is their 20V lithium-ion battery system. This technology provides ample power, allowing for longer run times compared to traditional battery systems. The LGC120 and LGC120B offer the convenience of cordless operation, eliminating the hassle of tangled cords and the need for access to power outlets, enabling users to freely navigate their yards.

The trim and edger function is another significant advantage. With a simple turn of the shaft, users can switch from trimming to edging, optimizing their gardening tasks. This feature is incredibly helpful for maintaining tidy borders along garden beds, driveways, and sidewalks, making the transition seamless and quick.

Weight is crucial when selecting a tool for garden maintenance, and the LGC120 and LGC120B are designed with lightweight materials, ensuring easy maneuverability and reduced fatigue during prolonged use. The adjustable height and pivoting head further enhance user comfort, accommodating various user heights and enabling precise trimming along uneven surfaces.

Moreover, both models incorporate automatic feed spool technology, allowing for hassle-free line advancement. This means users do not have to stop or manually feed the line, resulting in an uninterrupted working experience. The dual-line system provides a more efficient cutting capability, ensuring a cleaner finish and allowing for faster completion of lawn tasks.

Safety features are also incorporated into the design. The safety guard protects users from debris and ensures a safer operation, providing peace of mind while working.

In summary, the Black & Decker LGC120 and LGC120B are efficient, powerful, and user-friendly tools ideal for homeowners looking to maintain their lawns effectively. The combination of cordless convenience, powerful lithium-ion battery technology, and innovative features makes these models stand out in the lawn care equipment market, enhancing the overall gardening experience.
Top Page Image Contents