Specifications
Specifications
Model Numbers
Serial Nos: 720,000 and Higher
FR25KD
Systems
Engine
•Engine Specifications: See your Engine Owner’s Manual
•RPM: Full Speed: 3870
Load) Idle: 1400 ±50 RPM (No Load)
Fuel System
•Capacity: 8.5 gal. (32 L)
•Type of Fuel: Diesel fuel, 40 cetane or higher.
•Fuel Filter: Two
•Fuel gauge at the rear of the right hand fuel tank.
Electrical System
•Charging System: External Alternator
•Charging Capacity: 60 amps
•Battery Type: BCI Group 26
•Battery Voltage: 12 Volt
•Polarity: Negative Ground
•Fuses: One 15 amp, one 20 amp, and one 40 amp blade type
Safety Interlock System
•PTO must be disengaged, brake engaged, and motion control levers out (neutral lock) to start engine. (It is not necessary for the operator to be in the seat to start the engine.)
•Operator must be in seat when PTO is engaged, brake is disengaged, or motion control levers are moved in or engine will stop.
•Engine will stop if the motion control levers are moved from neutral position while brake is engaged.
Cooling System
•Fan: Belt driven with continuous operation with engine running.
•Coolant Liquid: 50/50 mix of DexCool© extended life antifreeze and water.
•Coolant Capacity: 4 quarts
Operator Controls
•Steering and Motion Control:
Note: Motion control levers are adjustable to three heights.
–Separate levers, on each side of the console, control speed and direction of travel of the respective drive wheels.
–Steering is controlled by varying the position of the levers relative to each other.
–Moving motion control levers outward (in slots) locks the drive system in neutral.
•PTO Engagement Switch: Engages drive to PTO (mower deck).
•Parking Brake Lever: Engages parking brake by pulling back.
Seat
•Type: Standard seat with high back, foam padded (internal suspension) and armrests and integral safety switch.
Optional seat accessories for units with standard seats:
–Custom ride suspension system to enhance Standard Seat.
–Deluxe suspension seat with high back, low profile
14