Husqvarna 11 Bio, 39765, 13 Bio manual Driving, Before starting, Starting the engine

DRIVING

Before starting

•Read the safety instructions and information on the location and function of the controls before starting (see pages 5–13).

•Conduct daily maintenance before starting (see maintenance schedule on page 19).

Adjust the seat to the required position.

Starting the engine

1.Lift up the cutting unit by pulling the lever back- wards to locked position (transport position).

2.Apply the parking brake. This is done as follows:

•Press down the brake pedal (1).

•Press in the lock button on the steering column (2).

•Release the brake pedal while the button is held pressed.

The parking brake lock disconnects automati- cally when the brake pedal is pressed down.

On the Rider 11 and Rider 11 Bio the brake pedal and lock button are on the right side.

2

1

Rider 13

3.For Rider 11 and Rider 11 Bio: Set the gear lever to position “N” (neutral).

IMPORTANT INFORMATION

Do not press the reverse lock button on the lever when you select neutral. If you do, it could trigger the start lock.

14 – English

N

Rider 11