Husqvarna 11 Bio, 39765, 13 Bio manual Checking and adjustment of the steering wires

Page 23

MAINTENANCE

Checking and adjustment of the steering wires

The steering is controlled by means of wires.

These can in time become slack, which implies that the adjustment of the steering becomes altered.

Check and adjust the steering as follows:

1. Dismantle the frame-plate by releasing the screws (two on each side).

2.Check the tension of the steering wires by

pushing them together as shown in the diagram. It should be possible to push them together so that the distance between them is half as much, without using unnecessary force.

3.When necessary the wires can be tensioned by tightening the adjusting nuts, one on each side

of the steering rim.

Do not tension the wires too tightly, they should only be tightened up to the steering rim.

Check the wire tension on completion of the adjustment as per item 2.

22 – English

Image 23

Contents 101 91 Rider 11/13 Rider 11 Bio/13 BioContents Towing InstructionDear customer Travel and transport on public roadsEngine Transmission Safety InstructionsGood service Serial numberExplanation of Symbols General use These instructions are for your safety. Read them carefullyDo as follows Driving on slopesChildren MaintenanceBattery can explode and cause severe injuries Location of the controls PresentationPresentation Brake pedal / Parking brake Presentation Rider 11 / 11 BIOThrottle and Choke lever Clutch pedalParking brake Presentation Rider 13/13 BIOSpeed limiter Rider 11 Bio and Rider 13 Bio have a twin-blade Cutting unitLift lever for cutting unit Fuelling Lever for adjustment of cutting heightSeat Starting the engine DrivingBefore starting Warm engine Cold engineFor Rider 11 and Rider 11 Bio Driving the machineFor Rider 13 and Rider 13 Bio Cutting tips Release lever Rider 13 and Rider 13 Bio Hill start, manual gearboxStopping the engine Daily Maintenance interval Hours Nance 100 MaintenanceMaintenance schedule Front hood Rider 11 Bio and Rider 13 Bio Dismantling of the machine hoodsEngine hood Front hood Rider 11 and RiderLeft-hand fender Right-hand fenderChecking and adjustment of the steering wires Checking the brake Rider 11 and Rider 11 Bio Adjusting the brake Rider 11 and Rider 11 BioCheck and adjust the brakes on Rider 13 and Rider 13 Bio Poorly adjusted brakes can result in reduced braking powerReplacement of the fuel filter Checking and adjustment of the throttle wireReplacing the air filter Do not use compressed air to clean the paper filterChecking of the fuel pump’s air filter Check the level of the battery acidProcedures on contact with acid Inspecting the safety system Check the engine’s cooling air intake Checking the tyre pressureChecking the cutting unit’s parallelism Maintenance Placing in service position Maintenance Rider 11 BIO/13 BIOService position for BioClip Maintenance Rider 11 BIO/13 BIO Restoring from service position Replacing the break-pin BioClip Checking the bladesChanging the oil LubricationCheck the engine’s oil level General lubrication Lubrication of belt tensionerLubrication of front wheel bearings Lubrication Rider 11 and Rider 11 BioProblem Procedure Trouble Shooting ScheduleWinter storage ServiceStorage Electrical system Technical DataDimensions Rider EngineDimensions Rider 11 Bio Rider 13 Bio EU declaration of conformity Only applies to Europe Work done Date, mileage, stamp, sign Servicejournal Rider 11/13Pre-delivery service Servicejournal Page 2000W50