Husqvarna 39765, 13 Bio, 11 Maintenance schedule, Daily Maintenance interval Hours Nance 100

MAINTENANCE

Maintenance schedule

The following is a list of the maintenance which should be conducted on the machine. For the items which are not described in these instructions go to an authorised service workshop.

		Daily	Maintenance interval
Maintenance	Page	mainte-		in hours
		nance	25	50	100
		before start
Check the engine’s oil level	35	●
Check the engine’s cooling air inlet	28	●
Check the fuel pump’s air filter	26	●
Check the steering wires	22	●
Check the brakes	23	●
Check the battery	26	●
Check the safety system	27	●
Check screws and nuts	–	❍
Check for fuel and oil leakage	–	❍
Change the engine oil 1)	35		●
Clean the air filter’s pre-filter (foam plastic) 2)	25		●
Check the cutting unit	29		●
Check the tyre pressures (60 kPa)	28		●
Lubricating the belt adjuster 3)	36		●
Lubricate joints and shafts 3)	37		●
Adjust the brakes – Rider 11 and Rider 11 Bio	23		●
Check the V-belts	–		❍
Check the transmission’s cooling flanges –	–		❍
Rider 13 and Rider 13 Bio
Check the transmission’s oil level – Rider 13 and	36			●
Rider 13 Bio
Adjust the brakes – Rider 13 and Rider 13 Bio	23			●
Check and adjust the throttle wire	24			●
Clean the cooling flanges on the engine and	–			❍
transmission 2,4)
Replace the air filter’s pre-filter and paper filter 2)	25				●
Replace the fuel filter	24				●
Replace the plug	–				❍

1)First change after 5 hours. 2) During dusty conditions cleaning and replacement should be more frequent. 3) For daily use of the machine lubrication should be conducted twice a week. 4) Conducted by authorised service workshop.

● = Described in these instructions.

❍= Not described in these instructions.

WARNING!

No service procedures must be conducted on the engine or cutting unit unless:

•	The engine is switched off.	•	The parking brake is applied.
•	The ignition key is removed.	•	The cutting unit is disengaged.

•The ignition cable is removed from the plug.

English – 19