Husqvarna 13 Bio, 39765, 11 Bio manual Maintenance Rider 11 BIO/13 BIO

Page 33

MAINTENANCE RIDER 11 BIO/13 BIO

4.Fit the support wheels on either side of the rear of the cutting unit.

WARNING!

Wear protective glasses when dismantling the cutting unit. The spring which tensions up the belt can go off and cause personal injury.

5.Disengage the spring from the drive belt tensioning wheel.

6. Move the cutting height lever to the lower position.

7. Place a foot on the front edge of the cutting unit near the wheel and raise the front edge of the unit to make it easier to remove the lift strut. Engage the strut in the holder.

32 – English

Image 33

Contents 101 91 Rider 11/13 Rider 11 Bio/13 BioContents Dear customer InstructionTravel and transport on public roads TowingGood service Safety InstructionsSerial number Engine TransmissionExplanation of Symbols General use These instructions are for your safety. Read them carefullyDo as follows Driving on slopesChildren MaintenanceBattery can explode and cause severe injuries Presentation PresentationLocation of the controls Throttle and Choke lever Presentation Rider 11 / 11 BIOClutch pedal Brake pedal / Parking brakePresentation Rider 13/13 BIO Speed limiterParking brake Cutting unit Lift lever for cutting unitRider 11 Bio and Rider 13 Bio have a twin-blade Lever for adjustment of cutting height SeatFuelling Driving Before startingStarting the engine Warm engine Cold engineDriving the machine For Rider 13 and Rider 13 BioFor Rider 11 and Rider 11 Bio Cutting tips Hill start, manual gearbox Stopping the engineRelease lever Rider 13 and Rider 13 Bio Maintenance Maintenance scheduleDaily Maintenance interval Hours Nance 100 Engine hood Dismantling of the machine hoodsFront hood Rider 11 and Rider Front hood Rider 11 Bio and Rider 13 BioLeft-hand fender Right-hand fenderChecking and adjustment of the steering wires Check and adjust the brakes on Rider 13 and Rider 13 Bio Adjusting the brake Rider 11 and Rider 11 BioPoorly adjusted brakes can result in reduced braking power Checking the brake Rider 11 and Rider 11 BioReplacement of the fuel filter Checking and adjustment of the throttle wireReplacing the air filter Do not use compressed air to clean the paper filterCheck the level of the battery acid Procedures on contact with acidChecking of the fuel pump’s air filter Inspecting the safety system Check the engine’s cooling air intake Checking the tyre pressureChecking the cutting unit’s parallelism Maintenance Maintenance Rider 11 BIO/13 BIO Service position for BioClipPlacing in service position Maintenance Rider 11 BIO/13 BIO Restoring from service position Replacing the break-pin BioClip Checking the bladesLubrication Check the engine’s oil levelChanging the oil General lubrication Lubrication of belt tensionerLubrication of front wheel bearings Lubrication Rider 11 and Rider 11 BioProblem Procedure Trouble Shooting ScheduleService StorageWinter storage Dimensions Rider Technical DataEngine Electrical systemDimensions Rider 11 Bio Rider 13 Bio EU declaration of conformity Only applies to Europe Servicejournal Rider 11/13 Pre-delivery serviceWork done Date, mileage, stamp, sign Servicejournal Page 2000W50