Husqvarna 39765, 13 Bio, 11 Bio manual Maintenance Rider 11 BIO/13 BIO, Service position for BioClip

Page 32

MAINTENANCE RIDER 11 BIO/13 BIO

Service position for BioClip 90

The cutting head can be placed in the service position to provide easy access for cleaning, repairs and servicing. In the service position the cutting unit is raised and locked in the vertical position.

Placing in service position

1.Position the machine on flat ground. Apply the parking brake (1), see page 10. Adjust the cutting unit to the lowest cutting height and lower the cutting unit.

2.Remove the front hood by removing the pin. (There are complete instructions on using the service position inside the front hood).

P

1

3.Remove the two support wheels from under the front hood.

English – 31

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Rider 11/13 Rider 11 Bio/13 Bio 101 91Contents Instruction Dear customerTravel and transport on public roads TowingSafety Instructions Good serviceSerial number Engine TransmissionExplanation of Symbols These instructions are for your safety. Read them carefully General useDriving on slopes Do as followsMaintenance ChildrenBattery can explode and cause severe injuries Location of the controls PresentationPresentation Presentation Rider 11 / 11 BIO Throttle and Choke leverClutch pedal Brake pedal / Parking brakeParking brake Presentation Rider 13/13 BIOSpeed limiter Rider 11 Bio and Rider 13 Bio have a twin-blade Cutting unitLift lever for cutting unit Fuelling Lever for adjustment of cutting heightSeat Starting the engine DrivingBefore starting Cold engine Warm engineFor Rider 11 and Rider 11 Bio Driving the machineFor Rider 13 and Rider 13 Bio Cutting tips Release lever Rider 13 and Rider 13 Bio Hill start, manual gearboxStopping the engine Daily Maintenance interval Hours Nance 100 MaintenanceMaintenance schedule Dismantling of the machine hoods Engine hoodFront hood Rider 11 and Rider Front hood Rider 11 Bio and Rider 13 BioRight-hand fender Left-hand fenderChecking and adjustment of the steering wires Adjusting the brake Rider 11 and Rider 11 Bio Check and adjust the brakes on Rider 13 and Rider 13 BioPoorly adjusted brakes can result in reduced braking power Checking the brake Rider 11 and Rider 11 BioChecking and adjustment of the throttle wire Replacement of the fuel filterDo not use compressed air to clean the paper filter Replacing the air filterChecking of the fuel pump’s air filter Check the level of the battery acidProcedures on contact with acid Inspecting the safety system Checking the tyre pressure Check the engine’s cooling air intakeChecking the cutting unit’s parallelism Maintenance Placing in service position Maintenance Rider 11 BIO/13 BIOService position for BioClip Maintenance Rider 11 BIO/13 BIO Restoring from service position Checking the blades Replacing the break-pin BioClipChanging the oil LubricationCheck the engine’s oil level Lubrication of belt tensioner General lubricationLubrication Rider 11 and Rider 11 Bio Lubrication of front wheel bearingsTrouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage Technical Data Dimensions RiderEngine Electrical systemDimensions Rider 11 Bio Rider 13 Bio EU declaration of conformity Only applies to Europe Work done Date, mileage, stamp, sign Servicejournal Rider 11/13Pre-delivery service Servicejournal Page 2000W50
Top Page Image Contents