Husqvarna 39765, 13 Bio, 11 Bio manual Inspecting the safety system

Page 28

MAINTENANCE

Inspecting the safety system

The Rider is equipped with a safety system that prevents starting or driving under the following conditions:

The engine should only be possible to start when the cutting unit is in its raised position and the hydrostat pedals are in the neutral position.

The driver does not need to be seated in the driver’s seat.

Make daily inspections to ensure that the safety system works by attempting to start the engine when one of the conditions is not met. Change the conditions and try again.

Check that the engine stops if you temporarily move out off the driver’s seat while the cutting unit is lowered or the hydrostat pedals are not in the neutral position.

StartmotorWorks

Ignition system

Does not work

N

Rider 11

Rider 13

English – 27

Image 28

Contents Rider 11/13 Rider 11 Bio/13 Bio 101 91Contents Instruction Dear customerTravel and transport on public roads TowingSafety Instructions Good serviceSerial number Engine TransmissionExplanation of Symbols These instructions are for your safety. Read them carefully General useDriving on slopes Do as followsMaintenance ChildrenBattery can explode and cause severe injuries Presentation PresentationLocation of the controls Presentation Rider 11 / 11 BIO Throttle and Choke leverClutch pedal Brake pedal / Parking brakeSpeed limiter Presentation Rider 13/13 BIOParking brake Lift lever for cutting unit Cutting unitRider 11 Bio and Rider 13 Bio have a twin-blade Seat Lever for adjustment of cutting heightFuelling Before starting DrivingStarting the engine Cold engine Warm engineFor Rider 13 and Rider 13 Bio Driving the machineFor Rider 11 and Rider 11 Bio Cutting tips Stopping the engine Hill start, manual gearboxRelease lever Rider 13 and Rider 13 Bio Maintenance schedule MaintenanceDaily Maintenance interval Hours Nance 100 Dismantling of the machine hoods Engine hoodFront hood Rider 11 and Rider Front hood Rider 11 Bio and Rider 13 BioRight-hand fender Left-hand fenderChecking and adjustment of the steering wires Adjusting the brake Rider 11 and Rider 11 Bio Check and adjust the brakes on Rider 13 and Rider 13 BioPoorly adjusted brakes can result in reduced braking power Checking the brake Rider 11 and Rider 11 BioChecking and adjustment of the throttle wire Replacement of the fuel filterDo not use compressed air to clean the paper filter Replacing the air filterProcedures on contact with acid Check the level of the battery acidChecking of the fuel pump’s air filter Inspecting the safety system Checking the tyre pressure Check the engine’s cooling air intakeChecking the cutting unit’s parallelism Maintenance Service position for BioClip Maintenance Rider 11 BIO/13 BIOPlacing in service position Maintenance Rider 11 BIO/13 BIO Restoring from service position Checking the blades Replacing the break-pin BioClipCheck the engine’s oil level LubricationChanging the oil Lubrication of belt tensioner General lubricationLubrication Rider 11 and Rider 11 Bio Lubrication of front wheel bearingsTrouble Shooting Schedule Problem ProcedureStorage ServiceWinter storage Technical Data Dimensions RiderEngine Electrical systemDimensions Rider 11 Bio Rider 13 Bio EU declaration of conformity Only applies to Europe Pre-delivery service Servicejournal Rider 11/13Work done Date, mileage, stamp, sign Servicejournal Page 2000W50