20CHAPTER 2: HARDWARE INSTALLATION
When positioning your Router, ensure:
■ It is out of direct sunlight and away from sources of heat.
■ Cabling is away from power lines, fluorescent lighting fixtures, and
| sources of electrical noise such as radios, transmitters and broadband |
| amplifiers. |
| ■ Water or moisture cannot enter the case of the unit. |
| ■ Air flow around the unit and through the vents in the side of the case |
| is not restricted. 3Com recommends you provide a minimum of |
| 25 mm (1 in.) clearance. |
Using the Rubber | Use the four |
Feet | moving around on your desk or when stacking with other flat top |
| OfficeConnect units. Only stick the feet to the marked areas at each |
| corner of the underside of your Router. |
Stacking the Router | If you are stacking your Router with other OfficeConnect units, install the |
| Router at the top of the stack. Refer to the documentation supplied with |
| your other OfficeConnect unit for details on using the stacking clip. |
| A stacking clip is not supplied with the Router. Use the stacking clip |
| supplied with another stackable OfficeConnect unit. |
|
|
Wall Mounting | There are two slots on the underside of the Router that can be used for |
| wall mounting. |
| When wall mounting the unit, ensure that it is within reach of the power |
| outlet.Do not install the Router more than 200 cm above the ground. |
| You will need two suitable screws to wall mount the unit. To do this: |
1Ensure that the wall you use is smooth, flat, dry and sturdy and make two screw holes which are 150 mm (5.9 in.) apart.
2Fix the screws into the wall, leaving their heads 3 mm (0.12 in.) clear of the wall surface.
3Remove any connections to the unit and locate it over the screw heads. When in line, gently push the unit on to the wall and move it downwards to secure.
