3Com 32x, 52x manual LEDs, Hardware, Interrupt Switch, Connectors, Cables

LEDs 2-3

MODEL: ESPL-310

NETBUILDER

REMOTE OFFICE 222

100-240VAC, 50/60HZ, 1.0-0.5A

250V, F2A

FOR CONTINUED PROTECTION

AGAINST FIRE HAZARD

REPLACE FUSE ONY WITH SAME TYPE AND RATING

S/N:

1SC05427

NTWK	080002	04BA1E		8.3
			LAN
ADDR:		04BA1F	WAN-A
		04BA20	WAN-B
		04BA21	WAN-C
07/31/95			20-0261-000

3COM CORP. SANTA CLARA, CA.MADE IN USA

On/off
switch	RPS	Product
Power
receptacle	connector	information label
	Figure 2-2	Chassis Back Panel

LEDs	See “LED Meanings” on page 4-3 for a complete description of the
	SuperStack II bridge/router LEDs.
Hardware	The hardware interrupt switch is located on the left side of the
Interrupt Switch	bridge/router (when facing the front panel). It is recessed into an
	opening near the DIP switches. Press the switch with a nonconductive
	object, such as a plastic stylus to put the system into the monitor
	firmware utility.
	WARNING: Use only a nonconductive object such as a plastic stylus to
	press the hardware interrupt switch. Do not use the tip of a pencil.
	Graphite particles from the pencil may cause you to receive an electric
	shock and damage components on the motherboard.
Connectors and	This section describes each connector on the bridge/router.
Cables
Console Cables	You can connect a PC running a terminal emulation program, a
	terminal, or a modem to the Console port on the SuperStack II
	bridge/router.

WARNING: To eliminate cable noise emission in excess of FCC Part 15, Subpart J, and EN55022 B, this device cable should be shielded and have connectors with metallic backshells.