3
UPGRADING MEMORY
The following memory upgrades are available from 3Com for your bridge/router:
■4 MB (3C8104) flash memory
■4 MB DRAM (3C8040)
Complete the following sections to install flash memory or DRAM in your SuperStack II bridge/router.
CAUTION: If you install the flash memory upgrade and then remove it from your system after startup, you will need to reload the system software using the procedures described in the software guide.
Removing the Cover
1Turn off the power and unplug the power cord from your SuperStack II bridge/router. Unplug the RPS cable, if connected.
2Remove the two screws on the back of the bridge/router.
MODEL: | S/N: |
|
|
|
|
| |||
NETBUILDER |
|
| 1SC05427 | ||||||
REMOTE OFFICE |
|
|
|
|
|
|
| ||
327 | NTWK | 080002 | 04BA1E | LAN | 8.3 |
|
| ||
ADDR: |
| 04BA1F |
|
|
| ||||
|
| 250V, F2A |
| 04BA20 |
|
|
| ||
|
|
|
| 04BA21 |
|
|
|
| |
FOR CONTINUED PROTECTION |
|
|
|
|
|
|
| ||
AGAINST FIRE HAZARD |
|
|
|
|
|
|
| ||
REPLACE FUSE ONY WITH |
|
|
| ||||||
SAME TYPE AND RATING | 07/31/95 |
| |||||||
3COM CORP. SANTA CLARA, CA. |
| MADE IN USA | |||||||
Remove these two screws
3Slide the cover back and up off the bridge/router.
