38CHAPTER 5: USING THE MODEM
S24
Bit 0. Error control fallback character (&N, \ C CMD)
■0 = No fallback character
■1 = Enable fallback character in S46
Bit 1. Error control buffer control (&O, \C CMD)
■0 = Don't buffer incoming data during negotiation
■1 = Buffer data
Bit 2. Data compression control (&U,%C CMD)
■0 = Disable
■1 = Enable
Bit 3. DCE speed to be negotiated during handshake (N CMD). Optimum speed up to
DTE if S37 = 255
■0 = negotiation followed bit 4
■1 = Optimum speed up to S37 if S37!= 255.
Bit 4. DCE speed to be negotiated during handshake (N CMD). Optimum speed up to
DTE if S37 = 255
■0 = S37 speed
■1 = Optimum speed if S37!= 255.
Bit 6,5. Extended connection result code (W, \V CMD)
■ 0 = No extended result code | |
■ 1 = Hayes extended result code | |
■ 2 = Microcom extended result code | |
■ 3 | = Not used |
Bit 7. DTE speed after handshake completed (&B, \J CMD) | |
■ 0 | = DTE set to DCE speed |
■ 1 | = DTE speed not changed by DCE |
| |
S25 DTR Detection. Value: 0 - 255 in .01 second or in 1 second increments (0 - 2.55 | |
seconds or 0 - 255 seconds) see &D command description. Default = 5. Storable. | |
| |
S26 RTS To CTS Delay. Value: 0 - 255 in .01 second increments (0 - 2.55 seconds). Default | |
= 1. Storable. | |
