S Registers 33
Common Registers
S0 | Ring To Answer On. 0 = No auto answer. Any other = Modem answers after this |
| number of rings. Default = 0. Storable. |
|
|
S1 | Ring Count. This register is reset to 0 if 8 seconds elapse since receipt of the previous |
| ring. Default = 0. Nonstorable. |
|
|
S2 | Escape Sequence Character. If the value is greater than 127, escape sequence is |
| disabled. Default = 43 (+). Value: 0 - 127. Nonstorable. |
|
|
S3 | Carriage Return Character. Default = 13 (ASCII CR). Value: 0 - 127. Nonstorable. |
|
|
S4 | Line Feed Character. Default = 10 (ASCII LF). Nonstorable. |
|
|
S5 | Backspace Character. Value: 0 - 255. Default = 8 (ASCII BS). Nonstorable. |
|
|
S6 | Wait Time For Dial Tone Or Before Dialing. Value: 2 - 255. Default = 2. Storable. |
|
|
S7 | Wait Time For Carrier / Second Dial Tone. Value: 1 - 255. Default = 30. Storable. |
|
|
S8 | Duration for Pause (,) Dial Modifier. Value: 0 - 255. Default = 2. Storable. |
|
|
S9 | Carrier Detect Response Time. Value: 1 - 255 (seconds). Default =1. Storable. |
|
|
S10 | Delay Between Lost Carrier And Hang Up. S10 = 255 implies infinite delay. Value: 1 - |
| 255 (seconds). Default = 14. Storable. |
|
|
S11 | DTMF Tone Duration and Silence Time Between Tones. Value: 50 - 255 (ms). Default |
| = 95. Storable. |
|
|
S12 | Escape Sequence Prompt Time. 55 in 20 ms increments (0 - 5.1 s). 0 = Do not check |
| guard time. Value: 0 - 2w. Default = 50. Storable. |
|
|
S13 | Caller ID. Storable. Bit 0 is used to enable/disable modem caller ID display and log. |
| ■ 0 = Disable modem caller ID display and log |
| ■ 1 = Enable modem caller ID display and log |
| Bits |
| ■ 0 = Basic caller display |
| ■ 1 = Extended caller display |
| ■ 2 = Rockwell formatted display |
| ■ 3 = Rockwell unformatted display |
|
|
