NetWare for Windows 3.1x, Windows for Workgroups, and DOS 3-9
NetWare for Windows 3.1x, Windows for Workgroups, and DOS
The AutoLink program installs DOS client software and
drivers for Novell NetWare in Windows 3.1x, Windows for
Workgroups 3.11, and DOS environments.
CAUTION: Do not use the AutoLink program if you are
running Windows 95 or Windows NT.
The AutoLink program modifies the CONFIG.SYS and
AUTOEXEC.BAT files. It logs on to the server and updates
the client software if your MIS department has already
configured a 3Install account on your server.

AutoLink Requirements

To use the AutoLink program, your computer should have
only one 3C905B-TX NIC installed and have 1 MB of free
hard disk space.

Running the AutoLink Program

1 Install the NIC and connect it to the network, as
described in Chapter 2.
2 Reboot, using a DOS diskette.
3 Insert EtherDisk Diskette #1 in drive A.
4 Run the Install program. Enter:
a:install
This opens the main menu.
5 From the main menu, select Auto Install and Config
for NetWare (AutoLink) and press Enter.
6 Select DOS, Windows 3.1x, or Windows for
Workgroups 3.11 and follow the instructions.
7 When the auto installation process is finished,
remove EtherDisk Diskette #1 and reboot the PC.
If you are running Windows 3.1x, after you connect to the
NetWare server, run the WSINSTALL program for full
Windows support. Contact your MIS department for the
location of this NetWare utility.
Book Page 9 Thursday, April 2, 1998 9:28 AM