| 135 |
|
|
Error message | Description |
|
|
Static Resource Conflict | Two or more Static Devices are trying to |
| use the same resource space (usually |
| Memory or I/O). |
PCI I/O conflict PCI ROM conflict PCI IRQ conflict
An I/O resource conflict was detected.
PCI IRQ routing table error | Unable to route an IRQ to the PCI device. |
|
|
Timer Error | An error occurred while programming the |
| count register of channel 2 of the 8254 |
| timer. |
|
|
Interrupt | The Master Interrupt Controller could not |
| be initialized. |
|
|
Interrupt | The Slave Interrupt Controller could not |
| be initialized. |
|
|
CMOS BIOS message |
|
|
|
CMOS Date/Time Not Set | The date and/or time values stored in the |
| CMOS are invalid. Run Setup to set correct |
| values. |
|
|
CMOS Battery Low | The battery maybe losing power. Replace |
| the battery soon. |
|
|
CMOS Settings Wrong | CMOS values are not the same as the last |
| boot. These values have either been |
| corrupted or the battery has failed. |
|
|
CMOS Checksum Bad | The CMOS checksum is incorrect. CMOS |
| memory may have been corrupted. Run |
| Setup to reset values. |
|
|
USB BIOS error messages |
|
|
|
Warning! Unsupported USB | A |
device found and disabled! | and disabled. |
Warning! Port 60h/64h emulation is not supported by this USB Host Controller!
The port 60h/64h emulation mode cannot be enabled for this USB host controller.